HIKVISION TurboHD H0T Series Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Keamanan HIKVISION TurboHD H0T Series. HIKVISION TurboHD H0T Series 17 halaman. Turbo hd bullet & dome camera
Juga untuk HIKVISION TurboHD H0T Series: Panduan Pengguna (17 halaman), Panduan Pengguna (16 halaman), Panduan Pengguna (17 halaman), Panduan Pengguna (13 halaman), Panduan Pengguna (18 halaman), Panduan Pengguna (15 halaman), Panduan Pengguna (15 halaman)

5. Route the cables through the cable hole, or the side

opening.

6. Connect the corresponding cables, such as power

cord, and video cable.

7. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, adjust the camera according to the figure below

to get an optimum angle

0° to 75°

Figure 2-10 Type I Camera 2-Axis Adjustment

1). Loosen the tilt adjusting screw to adjust the tilt

position [0° to 75°].

2). Hold the camera to adjust the pan position [0°

to 355°].

3). Hold the camera body to adjust the rotation

position [0° to 355°].

8. Reinstall the bubble, and tighten the screws to finish

the installation.

2.4 Ceiling Mounting of Type IV Camera

Steps:

1. Align the snap joint, and then insert the screw driver

to the snap joint.

Figure 2-9 Fix the Mounting Base

Figure 2-11 Bubble Reinstallation

0° to 355°

Adjusting Screw

0° to 355°

Align the

Snap Joint