KitchenAid KDFM404KPS Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring KitchenAid KDFM404KPS. KitchenAid KDFM404KPS 17 halaman.
Juga untuk KitchenAid KDFM404KPS: Manual (2 halaman)

Halaman Cetak

OPTIONS

Raises the main wash temperature to improve

cleaning for loads containing tough, baked-on

food.

Dries dishes with heat. This option, with the

use of rinse aid, will provide the best drying

performance. Plastic items are less likely to

deform when loaded in the top rack. Turn the

Heat Dry option off for an air dry.

Sanitizes dishes and glassware in accordance

with NSF International NSF/ANSI Standard 184

for Residential Dishwashers. Certified residential

dishwashers are not intended for licensed food

establishments. Only sanitizing cycles have

been designed to meet the requirements of the

NSF/ANSI 184 performance standard for soil

removal and for sanitization efficacy. There is

no intention, either directly or indirectly, that all

cycles on a NSF/ANSI 184 certified dishwasher

meet the NSF/ANSI 184 performance standard

for soil removal and for sanitization efficacy.

The Sani Rinse indicator glows at the end of the

cycle if the Sani Rinse option was successfully

completed. If the indicator does not activate, it

is probably due to the cycle being interrupted.

Runs the dishwasher at a later time or during

off-peak electrical hours. Select a wash cycle

and options. Touch the Delay keypad. Touch

START/RESUME. Close the door firmly.

NOTE: Anytime the door is opened (such as, to

add a dish), the Start/Resume keypad must be

touched again to resume the delay countdown.

Use the Control Lock option to avoid unintended use of dishwasher between cycles, or cycle and option changes during

a cycle.

To turn on Control Lock, touch and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short time,

indicating that it is activated. When the Lock indicator is lit, all keypad selections are disabled. If you touch any keypad

selection while your dishwasher is locked, the light flashes three times. The dishwasher door can still be opened/closed

while the controls are locked.

To turn off Control Lock, touch and hold CONTROL LOCK for 3 seconds. Control Lock light turns off.

CONTROL

To start or resume

a wash cycle.

To cancel a wash

cycle after it has

been started

To turn the

audible tones

on or off.

To indicate the

stauts of the

cycle.

cycle except

PURPOSE

If the door is opened during a cycle or the power is interrupted, the Start/Resume

indicator flashes. Cycle will not resume until the door is closed and Start is touched.

Close the door firmly. Touch and hold CANCEL/DRAIN for 3 seconds. The

dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely.

Touch and hold HI-TEMP WASH for 3 seconds to turn the audible tones on or

off. Only audible tones for confirming keypad touches can be turned on/off.

Important audible tones, such as indicating a cycle has been interrupted, cannot

be deactivated.

The display will indicate cycle progress such as Washing, Drying, Clean, and

Sanitized. The cycle has completed when the Clean light is lit.

If you select the Sani Rinse option, when the cycle is finished, the Sanitized

indicator glows. If the dishwasher did not properly sanitize your dishes, the

Sanitized indicator flashes at the end of the cycle. This can happen if the cycle is

interrupted or if water could not be heated to required temperature. The light goes

off when you open and close door or touch CANCEL.

CAN BE

WHAT IT DOES

SELECTED

WITH

ProWash™

Raises the main

wash temperate

Normal

up to 135°F (57°C).

Available

Activates the heating

with any

element at the end of

a wash cycle to speed

Rinse Only

drying times. Heat Dry

defaults to On when

any cycle is selected,

except for Express

Wash and Rinse Only.

ProWash™

Increases the main

wash temperature from

Normal

105°F (41°C) to 140°F

(60°C) and the final

rinse from 140°F (60°C)

to 155°F (68°C).

Available

Delays the start

with any

of a cycle to the

cycle

specified time.

COMMENTS

ADDED TIME

ADDED

TO CYCLE

WATER

(HR:MIN)

GALLONS

(LITERS)

0:00 to 0:30

0 to 3.0

(0 to 11.2)

Heat Dry:

0:10 to 0:50

Extended

Heat Dry

(includes Heat

Dry time):

0:40 to 1:20

0:00 to 2:20

1.2 to 6.2

(4.8 to 23.3)