KitchenAid KDFX 6050 Lembar Produk - Halaman 14
Jelajahi secara online atau unduh pdf Lembar Produk untuk Mesin pencuci piring KitchenAid KDFX 6050. KitchenAid KDFX 6050 16 halaman.
Halaman Cetak
What to do if...
If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy
the problem. Most faults can be remedied by taking the following courses of action, quickly restoring
normal appliance operation.
The appliance...
...is not working/will not start
... shows "F6 / E2" on the display or the
Cancel/Off light flashes alternately 6
times / 2 times
... shows "F6 / E7" or "F6 / E1" on the
display or the Cancel/Off light flashes
alternately 6 times / 7 times or 6 times
/ 1 time
... shows "F6 / E3" on the display or the
Cancel/Off light flashes alternately 6
times / 3 times
... shows "F8 / E1" on the display or the
Cancel/Off light flashes alternately 8
times / 1 time
... shows other faults "F.. / E.." on the
display of the Cancel/Off light flashes X
times
After taking the above course of action, no fault message should be displayed.
In the majority of cases the fault is thus eliminated.
RESET:
• Press the Cancel/Off button.
• Water drains automatically for up to 60 seconds with the door closed.
• The appliance is now ready to be restarted.
Possible causes/solutions
- The appliance must be switched on.
- Check the household circuit fuse if there is no power supply.
- The dishwasher door must be closed.
- Check whether the "Delayed Start" option has been selected (if
available). If it has, the appliance will only start once the set time
has elapsed. If you want to start the appliance before that time,
set the start delay to "0" (RESET).
- The water tap must be open.
- The water inlet hose must not be kinked and the relative inlet
filter in the water tap connector must not be dirty or clogged.
- The water tap must be fully open during water inlet (minimum
capacity: 0.5 litres per minute).
- The water inlet hose must not be kinked and the relative inlet
filter in the water tap connector must not be dirty or clogged.
- The filters must not be dirty or clogged.
- Concave items (e.g. bowls, cups) must be arranged facing
downwards in the rack.
- The drain hose must be fitted correctly (for raised built-in
appliances, leave min. 200-400 mm from the lower edge of the
appliance - see instructions in "Maintenance and Installation").
- The filters must not be dirty or clogged.
- The drain hose must not be kinked.
- The retaining washer of the syphon hose connection must be
removed.
- Reset the appliance (see below).
14