KitchenAid KDTE234GPS Petunjuk Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Mesin pencuci piring KitchenAid KDTE234GPS. KitchenAid KDTE234GPS 17 halaman.
Halaman Cetak
CONTROLS AND CYCLE STATUS
Control
Canceling a Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2. Press and hold CANCEL/DRAIN once. The Cancel/Drain light
will light up.
3. Close the door and the dishwasher starts a drain cycle (if
water remains in bottom of dishwasher). Let the dishwasher
drain completely. The Cancel/Drain light turns off after
2 minutes.
Changing a Cycle After Dishwasher Is Started
You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure:
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover
is open, you will need to re ll the detergent dispenser before
restarting your new cycle.
3. Press CANCEL/DRAIN and wait approximately 2 minutes until
the machine drains and the Cancel/Drain light turns off.
4. Select new cycles and options.
5. Press START/RESUME.
10
Purpose
To start or resume
If the door is opened during a cycle or the power is interrupted, the
a wash cycle.
Start/Resume indicator ashes.
NOTE: Push door rmly closed within 4 seconds of touching Start/
Resume. If the door is not closed within 4 seconds, the Start/Resume
keypad LED will ash, an audible tone will be heard, and the cycle will
not start.
To reset any cycle
Touch and hold CANCEL/DRAIN to reset any control selections made.
or options during
selection.
To cancel a wash
cycle after it has
been started
To turn the
Touch and hold HI-TEMP WASH for 3 seconds to turn the audible tones
audible tones
on or off. Only audible tones for con rming keypad touches can be
on or off.
turned on/off. Important audible tones, such as indicating a cycle has
been interrupted, cannot be deactivated.
To follow the
If you select the Sani Rinse option, when the cycle is nished, the
progress of the
Sanitized indicator on the control panel glows. If your dishwasher did
dishwasher cycle
not properly sanitize your dishes, the Sanitized indicator ashes at the
and to indicate
end of the cycle. This can happen if the cycle is interrupted or if water
the success of the
could not be heated to required temperature.
Sani Rinse.
The light goes off when you open and close door or touch
CANCEL/DRAIN.
Comments
Adding a Dish After Dishwasher Is Started
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop and then completely open the door.
2. If the detergent dispenser door is closed you may add a dish.
If the detergent dispenser door is already opened an added
dish might not be cleaned.
3. Press START/RESUME and close the door. If the door is not
closed within 4 seconds, you will hear a series of beeps and
the dishwasher will not start.