IKEA SOLVINDEN Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Pencahayaan Rumah IKEA SOLVINDEN. IKEA SOLVINDEN 32 halaman. Solar powered light-chain
Juga untuk IKEA SOLVINDEN: Manual (20 halaman), Manual (24 halaman), Manual (16 halaman), Manual (16 halaman), Manual (16 halaman), Manual (20 halaman), Panduan Memulai Cepat (16 halaman), Manual (12 halaman), Manual (20 halaman), Manual (12 halaman), Manual (12 halaman), Manual (20 halaman), Petunjuk Penggunaan Manual (16 halaman), Manual (20 halaman), Panduan Memulai Cepat (16 halaman), Manual (16 halaman), Manual (12 halaman), Manual (12 halaman), Manual (12 halaman), Manual (16 halaman), Petunjuk Manual (12 halaman), Manual (12 halaman), Manual (21 halaman), Manual (40 halaman)

Installation on Christmas Tree

Christmas trees because of the pine oils, and particularly

after being in a heated room for a week or two, are very

flammable. Tree decorations may also be flammable

and should be kept clear of the lamps as far as possible.

Christmas trees should be mounted securely so that they

are unlikely to fall over, or be knocked over by children or

pets. They must be kept clear of heat sources, including

spot lamps and particularly CANDLES.

Take care when decorating the tree, use a stepladder if

the tree is tall and wear shoes. Many more accidents are

caused by treading on plugs and lamps in bare feet than

faulty electrical equipment.

English

Guidance for Seasonal and Holiday lighting sets.

Follow these and any other instruction provided by

the manufacturer, it is for your safety.

1. Install the lighting chains so that there is easy access

to the socket-outlet so that the lights can be turned

off when you go out or go to bed. Never leave lighting

chains on when you go out or go to bed.

2. Do not remove or insert lamps while the lighting chain

is connected to the supply.

3. For series-connected lamps other than those in sealed

lighting chains, replace failed lamps immediately by

lamps of the same rated voltage and wattage to prevent

overheating; this requirement does not apply to sealed

lighting chains.