Ganz Thermal ZNT6-H Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kamera IP Ganz Thermal ZNT6-H. Ganz Thermal ZNT6-H 11 halaman. Fixed camera

Halaman Cetak
Fixed Camera Quick Start Guide
IP66 (Ethernet and AC/DC Power)
Securing for IP66 (Analog & AC/DC Power – Fixed Mount 320x240
& 640x480 Only)
1.
Slide the Coax cable through the threaded end of the cable sealing
gland, with Orange O-Ring installed
2.
Slide the 2, 20 AWG power wires (and any RS-485 wires) through
the back side of the cable sealing gland
3.
Measure approximately 4.5 inches of cable slack from the end of
the cable to the rubber grommet of the sealing gland. Use a scale
to measure the length
4.
Attach one open end wrench onto the flange of the cable gland
and tighten the compression nut, with the second open wrench, to
approximately 50-55 in-lbs. of torque
5.
Assemble a new RJ45 head to the Cat 5 Ethernet Cable
6.
Assemble a mating power connector to the 2 AC or 2 DC power
cables (and RS-485 cables if used).
Securing for IP66 (Analog & Ethernet – Fixed Mount 320x240 &
640x480 Only)
1.
Put the nut onto the cables first. And then push the analog video
cable (RG179BU required for this configuration) and CAT5 cable
through the gland. The CAT5 cable goes through the center. The
analog video goes through one of the 5 outer holes.
2.
Push the gland housing over the cables
3.
Push the gland rubber into the gland housing
5
www.ganzsecurity.com
November 2014