IKEA tradfri Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pencahayaan Rumah IKEA tradfri. IKEA tradfri 16 halaman. Motion sensor
Juga untuk IKEA tradfri: Panduan Pengguna (36 halaman), Manual Petunjuk Perakitan (36 halaman), Manual Petunjuk Perakitan (24 halaman), Manual (12 halaman), Manual (28 halaman), Manual (20 halaman), Manual (16 halaman), Manual (20 halaman), Panduan Cepat (36 halaman), Manual (16 halaman), Manual (32 halaman), Manual (12 halaman), Manual (8 halaman), Manual (24 halaman), Manual (24 halaman), Manual (32 halaman), Manual (24 halaman), Manual (32 halaman), Manual (32 halaman), Manual (24 halaman), Manual (12 halaman), Manual (24 halaman), Manual (24 halaman), Manual (24 halaman), Manual (29 halaman), Manual (12 halaman), Panduan Memulai Cepat (12 halaman), Manual (40 halaman), Panduan Memulai Cepat (24 halaman), Manual (16 halaman), Manual (24 halaman), Manual (32 halaman), Panduan Memulai Cepat (2 halaman), Manual (40 halaman), Panduan Memulai Cepat (16 halaman), Manual (36 halaman), Manual (28 halaman), Panduan Memulai Cepat (2 halaman), Manual (32 halaman), Manual (32 halaman), Manual (24 halaman), Petunjuk Manual (8 halaman), Manual (24 halaman), Panduan Memulai Cepat (4 halaman), Manual (8 halaman), Manual (20 halaman), Manual (12 halaman), Manual (8 halaman), Manual (32 halaman), Panduan Memulai Cepat (4 halaman), Manual (48 halaman)

Halaman Cetak

While pressing the button the blind is

lowered (until wished position or max

has been reached), if the button is

release the blinds stop.

Move blind up to top position

using buttons on Blind.

Single press the Upper (Top) button on

the Blind until blind has reaches the top

position.

Move blind down to preset level

using buttons on Blind.

Single press the Bottom (Lower) button

on the Blind until blind has reaches the

bottom position.

Move up blind using buttons on Blind.

Press and hold the Upper (Top) button

on the Blind.

Move down blind using

buttons on Blind.

Press and hold the Bottom (Lower)

button on the Blind

Set maximum level of extension

Move the blinds to the desired position

using the Open/Close remote or the

buttons on blind. When blind is at the

desired position, you can double press

the up or down button on the blind to

save this position as the new maximum

level of extension.

If you would like to clear the maximum

level of extension setting, first move the

blind to the top position. Afterwards,

double press either up or down button

on the blind .

You cannot perform this setting using

the Open/Close remote.

FACTORY RESET YOUR DEVICE

For wireless Open/Close remote:

Press the pairing button 4 times within

5 seconds.

For wireless roller blind:

Press on both buttons for 5 seconds. A

LED will blink once to confirm the reset.

For wireless signal repeater:

Push a pin into the pinhole on bottom

of the signal repeater for at least 5

seconds.

After reset the signal repeater you must

pair the Open/Close remote to the

signal repeater and then pair the Open/

Close remote to the roller blind again.

CHANGING THE BATTERY

When the wireless Open/Close remote

is used regularly and as intended, the

battery will last for approximately 2

years.

When it's time to replace the battery, a

red LED indicator will flash when you

toggle the Open/Close remote.

Open the rear cover, and replace the

battery with a new CR2032 battery.

CAUTION!

Risk of explosion if battery is replaced

by an incorrect type. Dispose of used

batteries according to the instructions.