IKEA IDT930SAGX0 Petunjuk Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Mesin pencuci piring IKEA IDT930SAGX0. IKEA IDT930SAGX0 15 halaman.

Halaman Cetak

CONTROLS AND CYCLE STATUS

CONTROL

Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the Lock

indicator is lit, all buttons are disabled. The dishwasher door can still be opened/closed while the controls are

locked.

Press to start or resume a

wash cycle.

To cancel a wash cycle after it

has been started.

To follow progress of

your dishwasher cycle.

Your dishwasher has the latest technology in dishwasher filtration. This triple filtration system minimizes sound and optimizes water

and energy conservation while providing superior cleaning performance. Throughout the life of your dishwasher, the filter will require

maintenance to sustain peak cleaning performance.

The triple filter system consists of 2 parts, an upper filter

assembly and a lower filter.

The upper filter assembly keeps oversized items and foreign

■

objects, along with very fine food particles, out of the pump.

The lower filter keeps food from being recirculated onto your

■

dishwasher.

The filters may need to be cleaned when:

Visible objects or soils are on the upper filter assembly.

■

There is degradation in cleaning performance (that is, soils

■

still present on dishes).

Dishes feel gritty to the touch.

■

It is very easy to remove and maintain the filters. The chart below

shows the recommended cleaning frequency.

Number of Loads

If you only scrape before loading* If you scrape and rinse before loading

Per Week

8-12

Every two months

4-7

Every four months

1-3

Twice per year

*Manufacturer's recommendation: This practice will conserve the water and energy that you would have used to prepare your dishes.

This will also save you time and effort.

Very Hard Water

If you have hard water (above 15 grains), clean your filter at least

once per month. Building up of white residue on your dishwasher

indicates hard water. For tips on removing spots and stains, see

the "Troubleshooting" section.

PURPOSE

If the door is opened during a cycle or the power is interrupted, the

START/RESUME LED flashes. The cycle will not resume until the

START/RESUME keypad is pressed and the door is closed.

NOTE: Push door firmly closed within 4 seconds of pressing

START/RESUME or the dishwasher will not start. If door is not closed within

4 seconds the START/RESUME LED will flash and an audible tone will sound

when the door is closed.

Press to cancel a wash cycle. then, close the door firmly. The dishwasher

starts a 2-minute drain (if needed). Let the dishwasher drain completely.

If you select the Sani Rinse option, when the cycle is finished, the

"Sanitized" indicator glows.

If your dishwasher did not properly sanitize your dishes, the light flashes

at the end of the cycle. This can happen if the cycle is interrupted or water

could not be heated to required temperature.

The light goes off when you open and close door or press CANCEL.

Filtration System

RECOMMENDED TIME INTERVAL TO CLEAN YOUR FILTER

Every four months

Once per year

COMMENTS

Upper filter

assembly

Lower filter

If you wash before loading

Once per year