IKEA IUD9500WX0 Panduan Petunjuk Instalasi - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring IKEA IUD9500WX0. IKEA IUD9500WX0 44 halaman. Undercounter dishwasher plastic giant tub models
Juga untuk IKEA IUD9500WX0: Petunjuk Pengguna (25 halaman)
Halaman Cetak
Tip Over Hazard
Do not use dishwasher
until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
1=
2=
3.
If you have not already done so, open dishwasher door and
place towel over pump assembly and spray arm of
dishwasher. This will keep screws from falling into pump area
when securing dishwasher to countertop.
Check that dishwasher is still level and centered side to side in
the opening.
Secure dishwasher to countertop or sides of cabinet with two,
#10 x V2" Phillips-head screws. The dishwasher must be
secured to keep it from tipping when door is opened. Do not
drop screws into bottom of dishwasher.
A. Screw to countertop
A. Screw to side cabinet
4=
5=
Open door about 3" (7.6 cm) and check that space between
inner door and tub is equal on both sides. If spacing is not
equal, loosen bracket screws and shift tub. Tighten bracket
screws.
If using a countertop attachment to secure dishwasher, check
that top of door does not contact screws, brackets, or
countertop.
If it does, dishwasher must be lowered and re-
leveled.
6=
If securing with a side attachment, check that sides of door do
not rub against the screw heads. If they do, dishwasher must
be re-centered. When dishwasher is properly centered,
replace plastic buttons.
A. Plastic button
7. Remove towel from dishwasher.
8. Reinstall the lower dish rack.
1=
2.
A_
Check that grounding clip is attached to the lower panel.
Place the lower panel behind the access panel. Some models
have insulation on the access panel which must fall behind the
insulation on the lower panel.
B
A. Access panel
B. Lower panel
C. Grounding clip
3. Hold the two panels together and push them up against
dishwasher leg and vinyl pad.
4. Reinstall the screws through the holes in the access panel and
the slots in the lower panel. Install right side screw first.
5. Check that the lower edge of the lower panel contacts the
floor.
6. Tighten the screws.
19