IKEA LAGAN Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring IKEA LAGAN. IKEA LAGAN 20 halaman. Examples of the load of the basket
Juga untuk IKEA LAGAN: Manual Petunjuk Perakitan (8 halaman), Panduan Pengguna (20 halaman), Panduan Pengguna (16 halaman), Petunjuk Manual (48 halaman), Panduan Pengguna (16 halaman), Panduan Pengguna (24 halaman), Manual (28 halaman), Buku Petunjuk (24 halaman), Panduan Pengguna (24 halaman), Manual (24 halaman), Manual (4 halaman), Panduan Pengguna (12 halaman), Manual (24 halaman), Manual Petunjuk Perakitan (20 halaman), Panduan Instalasi (20 halaman), Manual (28 halaman), Manual (32 halaman), Manual (44 halaman), Manual (16 halaman), Manual (16 halaman), Manual (24 halaman), Manual (28 halaman), Manual (28 halaman), Panduan Pengguna (28 halaman), Manual (40 halaman), Manual (48 halaman), Panduan Penggunaan & Perawatan (25 halaman), Manual (44 halaman), Manual (40 halaman), Manual (28 halaman), Manual (28 halaman), Panduan Pengguna (24 halaman), Manual (48 halaman), Panduan Pengguna (16 halaman), Panduan Petunjuk Instalasi (18 halaman), Manual (48 halaman), Panduan Memulai Cepat (4 halaman), Panduan Petunjuk Instalasi (16 halaman), Manual (28 halaman), Manual (28 halaman), Manual (44 halaman), Manual (48 halaman), Manual (16 halaman), Manual (32 halaman), Manual (24 halaman), Manual (25 halaman), Manual (18 halaman), Panduan Pengguna (28 halaman), Manual (44 halaman), Manual (24 halaman), Manual (32 halaman), Manual (18 halaman), Manual (48 halaman), Manual (29 halaman), Manual (29 halaman), Manual (34 halaman), Panduan Petunjuk Instalasi (42 halaman)

Halaman Cetak

ENGLISH

Problem

The salt indicator con-

tinues to stay on after

the replenishment of

the salt container.

After the checks are completed, activate the

appliance. The programme continues from

the point of interruption.

If the problem occurs again, contact the

service.

If other alarm codes show, contact the serv-

ice.

If the washing and drying results are not

satisfactory

Whitish streaks or bluish layers on glasses

and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a

lower position.

• The quantity of detergent is too much.

Stains and dry water drops on glasses

and dishes

• The released quantity of rinse aid is not

sufficient. Adjust the rinse aid selector to

a higher position.

Technical information

Dimensions

Electrical connection

Water supply pressure

Water supply

Capacity

Power consumption

1) Connect the water inlet hose to a water tap with a 3/4'' thread.

2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water

supply to decrease energy consumption.

Possible cause

This can occur when you are

using salt that needs more time

to dissolve.

There is no unwanted effect on

the performance of the appli-

ance.

Width / Height / Depth (mm)

Refer to the rating plate.

Voltage

Frequency

Min. / max. (bar / MPa)

Cold water or hot water

Place settings

Left-on mode

Off-mode

Possible solution

If after 3 or 4 programmes, the

salt indicator continues to stay

on, contact the service.

• The quality of the detergent can be the

cause.

Dishes are wet

• The programme is without a drying

phase or with a low temperature drying

phase.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the

cause.

Refer to 'HINTS AND TIPS' for other

possible causes.

596 / 820 - 880 / 555

220-240 V

50 Hz

(0.5 / 0.05 ) / (8 / 0.8 )

max. 60 °C

0.99 W

0.10 W