Gap Power Speedrooter 92R Panduan Petunjuk Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pembersih pipa Gap Power Speedrooter 92R. Gap Power Speedrooter 92R 10 halaman. For 3” through 10” (75mm-250mm)

Halaman Cetak

Speedrooter 92R

SPECIFIC SAFETY RULES

This is the safety alert symbol. It is used to alert

you to potential personal injury hazards. Obey all

safety messages that follow this symbol to avoid

possible injury or death.

Electric shock resulting in death can occur if you

plug this machine into an improperly wired outlet. If

the ground wire is electrified, you can be electrocuted

by just touching the machine, even when the power

switch is off. A ground fault circuit interrupter will not

protect you in this situation. Use a UL approved tester to

determine if the outlet is safe.

Do not overstress cables. Overstressing cables may

cause twisting, kinking, or breaking of the cable and may

result in serious injury.

Only wear leather gloves. Never use any other type of glove,

such as cloth, rubber, or coated gloves. Never grasp a rotating

cable with a rag. These items could become wrapped around the

cable and cause serious injury.

Never operate machine with belt guard removed. Fingers can

get caught between belt and pulley.

Never operate machine without Guide Tube in place. Can result in

significant hand injury.

Do not overstress cables. Keep leather-gloved hand on the

cable for control when machine is running. Overstressing cables

because of an obstruction may cause twisting, kinking, or break-

ing of the cable and may result in serious injury.

Place the machine at a distance not greater than two feet

from the opening. Greater distances can result in cable twisting

or kinking.

Machine is designed for ONE-PERSON operation. Operator

must control foot switch and cable.

Do not operate machine in reverse (REV). Operating machine

in reverse can result in cable damage and is used only to back

cutting tool out of an obstruction.

Keep hands away from rotating drum. Do not reach into drum

unless machine is unplugged. Hand may be caught in the moving

parts resulting in serious injury.

Be careful when cleaning drains where cleaning chemicals

have been used. Avoid direct contact with skin and eyes. Drain

cleaning chemicals can cause serious burns as well as damage

the cable.

10. Do not operate machine if operator or machine is standing

in water. Will increase risk of electrical shock.

11. Wear safety glasses and rubber soled, non-slip shoes. Use

of this safety equipment may prevent serious injury.

12. Before starting each job, check that the cable in the drum is

not broken or kinked, by pulling the cable out and checking

for wear or breakage. Always replace worn out (kinked or bro-

ken) cables with genuine GENERAL replacement cables.

13. Only use this tool in the application for which it was de-

signed. Follow the instructions on the proper use of the ma-

chine. Other uses or modifying the drain cleaner for other appli-

cations may increase risk of injury.

Ground Fault Circuit Interrupter (GFCI)

Your machine is equipped with a ground fault circuit interrupter, which

protects you against shock if a short circuit should occur. Check that

receptacle is properly grounded. Test the GFCI before each use.

Plug into 120-volt receptacle.

Push test button. Indicator light will go out and power to machine

should cut off.

If light does not go out when test button is pushed, equipment

should not be used until proper repairs can be made.

To restore power after test, push reset button. With the reset

button depressed, if the machine doesn't start, stops while run-

ning, or if the operator experiences a mild shock, do not use the

machine! Tag the machine out of service and take it to a motor

repair center or return it to the factory for repairs.

THE SECTION OF CORD BETWEEN THE WALL PLUG

AND THE GFCI IS NOT IN THE PROTECTED CIRCUIT.

FEATURES

Truck Loading Wheel

Condensed

Operating

Instructions

Momentary

Contact

Motor Switch

Stair

Climbers

V-Belt

Passive

Brake

Open

Flexitube Spring

Drum

Distributor Tube

Cable Application Chart (Table 1)

Cable Size

Pipe Size

3/4"

4" to 10"

5/8"

3" to 6"

Folding Handle

Cord Wrap

Belt Guard

Feed Pressure

Control Knob

Feed Control

Lever

Foot Pedal

Cutter

Guide Tube

Typical Applications

Large Drains, Long Runs, Roots

Floor Drains, Roots