Bernhard RF1000 Panduan Pengguna/Petunjuk Penggunaan - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna/Petunjuk Penggunaan untuk Peralatan Servis Bernhard RF1000. Bernhard RF1000 15 halaman. Bedknife front facing device
Halaman Cetak
5.2.4
To increase the cut rotate the eccentric adjustment lever (item 10) on each magnet
assembly by a few degrees clockwise.
5.2.5
If the grinding disc is not in contact with the front face everywhere, a further movement of
the lever will be necessary. Finish off with a light cut.
5.2.6
NOTE: Regularly maintained blades will need very few cuts. Damaged blades will need
more.
5.2.7
Turn off the air and disconnect the air line.
5.2.8
Check that the ground finish on the bedknife edge is satisfactory.
5.2.9
Remove the Rapid Facer from the bedknife.
5.2.10 Rotate the reel and check that the cutting clearance is correct all along the full length of
each blade.
NOTE: Set the reel to cut paper at between .002" and .004" (.05mm-.1mm) clearance.
For best results trap one Bernhard Cutting Strip between reel and bedknife.
© Bernhard and Company Limited
RAPID FACER MANUAL
10