GAPOSA XQ5 Panduan Cepat Pemrograman - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Cepat Pemrograman untuk Tirai Jendela GAPOSA XQ5. GAPOSA XQ5 3 halaman.
Halaman Cetak
3"
<15"
1
ON
OFF
ON
PREFERRED POSITION
1. SETTING AN PREFERRED POSITION
Operate the motor to and stop it at the desired intermediate position, then press both the UP
and DoWN buttons together until the motor makes a brief jog to confirm.
The intermediate position is now set.
2. RECALLING THE PREFERRED POSITION
Press and hold the SToP button for 3 seconds: the motor will move to and stop at the
intermediate position.
3. ERASING THE PREFERRED POSITION
Press both the UP and DoWN buttons until the motor makes a brief jog to confirm.
The intermediate position is now erased.
5"
2
AUTOMATIC SETTING OF THE LIMITS
For limits set with torque sensor (mechanical stop of shutters or cassette awnings/
shades), press and hold the UP button until the bottom bar hits the cassette or
shutter box. A short jog will indicate that the UP position has been memorized.
The same procedure can be followed for the DoWN limit but only for roller shutters.
(Sec. 7)
DELETING A TRANSMITTER OR A CHANNEL
Using the transmitter to be deleted press and hold both the SYNC and SToP
buttons untill the motor makes a brief jog to confirm.
Only the transmitter used for this procedure has been deleted from motor
memory
RESET TRANSMITTER MEMORY
(DELETING ALL THE TRANSMITTERS OR CHANNELS OR
SENSORS)
Option 1 - Using a programmed transmitter
Press and hold both the SYNC and SToP buttons for at least
15 seconds: to confim that the operation has completed, the
motor first makes a brief jog and after 5 seconds it makes an
additional jog. This operation will not be successful unless it
makes both jogs.
Memory is now empty
Option 2 - Using a new transmitter without ID (not
paired).
1 Switch the power to the motor OFF, then switch it back ON.
2 Within 8 seconds, using any Gaposa transmitter, press and
hold both the SYNC and SToP buttons until the motor
makes a jog.
Memory is now empty
Option 3 - White button on the head of the motor
Press and hold the white button on the head of the motor
until the motor starts to move. Release the white button.
All transmitters have been erased.
(Sec. 6)
(Sec. 8)
(Sec. 9)