Makita 1806B Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 1806B. Makita 1806B 10 halaman. Power planer
Juga untuk Makita 1806B: Buku Petunjuk (17 halaman), Perincian Bagian (3 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (11 halaman)

Halaman Cetak

OPERATING INSTRUCTIONS

Removing or installing planer blades

(Fig. 1, 2 & 3)

Important:

• Always be sure that tool is switched off and

unplugged before removing or installing the blade.

• Use the following planer blades.

Part Nos. 793186-4 *P-04254

Blades with * mark are available in European coun-

tries only. Consult your dealer or the Makita Service

Center when purchasing blades.

To remove the blades on the drum, unscrew the five

installation bolts with the hex wrench. The drum cover

comes off together with the blades.

To install the blades, first clean out all chips or foreign

matter adhering to the drum or blades. Use blades of

the same dimensions and weight, or drum oscillation

/vibration will result, causing poor planing action and

eventually tool breakdown.

There are two adjusting screws for each blade. When

installing the blade, the notch in the blade should fit

over the head of the adjusting screw. Then fit on the

drum cover and secure the five bolts only finger-tight.

For the correct planer blade setting

Your planing surface will end up rough and uneven, unless the blade is set properly and securely. The blade

must be mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base.

Below are some examples of proper and improper settings.

(A) Front base (Movable shoe)

(B) Rear base (Stationary shoe)

Correct setting

Nicks in surface

Gouging at start

Gouging at end

Turn the drum until the blade edge is right in the

middle between the front and rear bases.

Place the triangular rule flat on the rear base and run

it out over and across the blade edge. Turn the two

adjusting screws to adjust the blade protrusion. The

blade setting should be made so that the protrusion

will be uniform all the way across. Thus the triangular

rule should be flush with the entire width of the blade

edge. After adjusting both blades, tighten the five

installation bolts evenly and alternately with the hex

wrench.

After tightening the bolts, secure the adjusting screws

fully.

CAUTION:

Tighten the blade installation bolts carefully when

attaching the blades to the tool. A loose installa-

tion bolt can be dangerous. Always check to see they

are tightened securely.

Although this side view cannot show

it, the edges of the blades run

perfectly parallel to the rear base

surface.

Cause: One or both blades fails to

Cause: One or both blade edges fails

Cause: One or both blade edges

have edge parallel to rear

base line.

to protrude enough in relation

to rear base line.

protrudes too far in relation to

rear base line.