Avantco 177MX10H Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengaduk Avantco 177MX10H. Avantco 177MX10H 12 halaman. Gear driven 10 qt. commercial mixer

Halaman Cetak
Avantco 177MX10H Panduan Pengguna

REMOVAL AND REFITTING INSTRUCTIONS MIXER SAFETY GUARD

1. To remove the wire guard adjust the position to align the edge of the wire guard with the single indentation marker on the
fixed rear guard. See figure 1.
2. Remove the rubber closing caps from the mounting screws as in the indicated positions. Remove the screws. See figure 2
and 3.
3. Turn the wire guard until the edge of the wire aligns with two indentation markers on the fixed rear guard. See figure 4.
4. Remove the cap and mounting screw in the indicated position. See figure 5.
5. Ensure that all rubber caps are fitted properly into the screw heads. See figure 6.
6. To replace the wire guard after cleaning repeat the instructions above in reverse.
www.AvantcoEquipment.com
Figure 1
Figure 2
Figure 4
Figure 6
User Manual
Figure 3
Figure 5
5