Makita 1923H Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 1923H. Makita 1923H 13 halaman. Power planer
Juga untuk Makita 1923H: Buku Petunjuk (17 halaman), Buku Petunjuk (18 halaman)

Halaman Cetak

002584

010709

CAUTION:

The blade edge should be made to protrude

•

outside slightly (0.3 mm - 0.6 mm). Otherwise,

nicks and generally poor shiplapping results.

0.3 - 0.6 mm

004900

Chamfering

003634

004901

1. V groove

To make a chamfering cut as shown in the figure, align

the "V" groove in the front base with the edge of the

workpiece and plane it.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or the

•

like. Discoloration, deformation or cracks may result.

Sharpening the planer blades

For standard blades only

Always keep your blades sharp for the best performance

possible. Use the sharpening holder to remove nicks and

produce a fine edge.

002588

First, loosen the two wing nuts on the holder and insert

the blades (A) and (B), so that they contact the sides (C)

and (D). Then tighten the wing nuts.

002589

Immerse the dressing stone in water for 2 or 3 minutes

before sharpening. Hold the holder so that the both

blades contact the dressing stone for simultaneous

sharpening at the same angle.

002590

1. Sharpening

holder

1. Wing nut

2. Blade (A)

3. Blade (B)

4. Side (D)

5. Side (C)