CORNING PC-400D Buku Petunjuk - Halaman 9
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Laboratorium CORNING PC-400D. CORNING PC-400D 14 halaman. Digital hot plates, stirring hot plates, stirrers, and external temperature controller
Juga untuk CORNING PC-400D: Buku Petunjuk (11 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (14 halaman)
Halaman Cetak
If an error routine is engaged, the product will typically shut down. Some error routines will
display an error code number in the left digital location of the Heating Temperature Display
when the product is shut down. For more information on error codes, contact Corning
Scientific Support at 978.442.2200.
A product shut down by an error routine must be disconnected and reconnected to mains input
before it can be used again. Please contact Corning Life Sciences or a Corning authorized repair
facility (visit www.corning.com/lifesciences) if a product does not reset from the error routine
shut down or if it continues to shut down after resetting.
CAUTION: Error routines built into these products do not substitute the need to
use these products per the specified operating conditions and according to safe
laboratory practices. There are potential failure modes in product functionality or
in the process of use that could result in uncontrolled or unexpected heating of
the top surface. Reaction plans should be developed and safety precautions put
in place based on the worse case scenario that any materials placed on the top
surface could be subjected to a continuous supply of heat, raising the material
temperature to levels in excess of 550°C.
8.0 Repair
There are no direct user serviceable components inside this series of products.
Please contact Corning or a Corning authorized repair facility for repair or maintenance issues.
9.0 Maintenance
Power
CAUTION: Disconnect power to the product by unplugging the power cord before
performing any maintenance or inspection procedures.
Inspect the power cord regularly and replace if damaged. Use only replacement power
cords available from Corning or Corning authorized product distributors.
Ceramic Top Plate
These products are supplied with a Pyroceram® top that is easy to clean and highly
resistant to scratches, corrosion, and chemical attack.
The ceramic top may break during use if not properly maintained.
Keep the ceramic top clean. A nonabrasive cleaner may be used to clean the ceramic top.
Inspect the ceramic top for damage during cleaning.
Discontinue product use if the ceramic top is chipped, etched, or shows excessive scratching.
Contact Corning or a Corning authorized repair facility for a top replacement.
General
It is important to keep this product dry and clean.
Remove minor exterior liquid spills promptly.
Clean exterior surfaces with a nonabrasive cleaner. Do not reconnect product to power
input until all cleaned surfaces have dried.
If liquid or wet solid material gets inside the product, immediately disconnect the power
to the product and discontinue use. Contact Corning for additional instructions regarding
interior spills.
Instruction Manual
9