CORNING Centrix Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan CORNING Centrix. CORNING Centrix 2 halaman. System splitter/cwdm cassette installation
Juga untuk CORNING Centrix: Petunjuk Manual (8 halaman), Perutean Jumper (20 halaman)

Halaman Cetak

Connect Jumpers to Splitter/CWDM Cassettes

WARNING: Never look directly into the end of a fiber that may be carrying laser light. Laser light can

be invisible and can damage your eyes. Viewing it directly does not cause pain. The iris of the eye will

not close involuntarily as when viewing a bright light. Consequently, serious damage to the retina

of the eye is possible. Should accidental eye exposure to laser light be suspected, arrange for an eye

examination immediately.

Step 1:

Press latch on the right side of the cassette. Pull the cassette out to the detent position (Figure 3).

Step 2:

Press buttons on each side of the cassette and lower the handle.

TPA-4699

Step 3:

Remove dust caps and clean adapters and connectors per standard company practices.

Step 4: Refer to the designation label (Figure 2) on the handle of the cassette for the port designations to

determine where your jumpers should be connected.

• Connect the input or common port jumper to the port labeled "IN" or "COM."

• Connect the remaining jumpers to the appropriate port as shown on the designation label.

Step 5:

Connect jumpers (Figure 4) as required.

Step 6: Raise handle. Dress all jumper cords to the left side and through the jumper retainer clip shown in

Figure 4 before rotating the drop handle up and closing the cover..

Step 7:

Push cassette back into the housing and dress jumper cords in frame as described in the installation

instruction provided with the housing.

IMPORTANT:

Guide fibers while inserting cassette to avoid pinching fibers.

TPA-4700

Corning Optical Communications LLC • PO Box 489 • Hickory, NC 28603-0489 USA

800-743-2675 • FAX 828-325-5060 • International +1-828-901-5000 • www.corning.com/opcomm

Corning Optical Communications reserves the right to improve, enhance, and modify the features and specifications of Corning Optical Communications products without

prior notification. A complete listing of the trademarks of Corning Optical Communications is available at www.corning.com/opcomm/trademarks. All other trademarks are

Mexico.

STANDARD RECOMMENDED PROCEDURE 003-959 | ISSUE 3 | APRIl 2017 | PAGE 2 OF 2

Button

Figure 3

Figure 4