Makita 4329 Buku Petunjuk - Halaman 5
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 4329. Makita 4329 13 halaman. Jig saw
Juga untuk Makita 4329: Buku Petunjuk (13 halaman), Spesifikasi (2 halaman), Buku Petunjuk (13 halaman), Informasi Teknis (7 halaman), Buku Petunjuk (13 halaman)
Halaman Cetak
6.
Check for the proper clearance beyond the
workpiece before cutting so that the blade will
not strike the floor, workbench, etc.
7.
Hold the tool firmly.
8.
Make sure the blade is not contacting the
workpiece before the switch is turned on.
9.
Keep hands away from moving parts.
10. Do not leave the tool running. Operate the tool
only when hand-held.
11.
Always switch off and wait for the blade to
come to a complete stop before removing the
blade from the workpiece.
12. Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
13. Do
not
operate
unnecessarily.
14. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
15. Always use the correct dust mask/respirator
for the material and application you are
working with.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Selecting the cutting action (For models
4328/4329)
008153
the
tool
at
1. Cutting action
changing lever
1
This tool can be operated with an orbital or a straight line
(up and down) cutting action. The orbital cutting action
thrusts the blade forward on the cutting stroke and
greatly increases cutting speed.
To change the cutting action, just turn the cutting action
changing lever to the desired cutting action position.
Refer to the table to select the appropriate cutting action.
Position
0
no-load
006582
Switch action
1
008082
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
5
Cutting action
For cutting mild steel,
stainless steel and plastics.
Straight line
cutting action
For clean cuts in wood
and plywood.
Small orbit
For cutting mild steel,
cutting action
aluminum and hard wood.
For cutting wood and
plywood.
Medium orbit
cutting action
For fast cutting in aluminum
and mild steel.
Large orbit
For fast cutting in wood
cutting action
and plywood.
2
Applications
1. Switch trigger
2. Lock button