HIKVISION DS-7208HTI-K2 Panduan Memulai Cepat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk DVR HIKVISION DS-7208HTI-K2. HIKVISION DS-7208HTI-K2 15 halaman.

I N S T A L L A T I O N ( c o n t i n u e d )

 Connecting PTZ to the DVR

1. Disconnect

RS-485 terminal block.

2. Connect A+ on PTZ to D+ on terminal

block and B- on controller to D- on

terminal block.

3. Fasten stop screws.

4. Connect pluggable block back into

terminal block.

Make sure both the controller and

the DVR are grounded.

M E N U O P E R A T I O N

 Startup

Proper startup is crucial to extending the life of the DVR.

It is HIGHLY recommended that an Uninterruptible Power Supply (UPS) be used in conjunction with the

device. The Power light on the front panel should be red, indicating the device is receiving power.

1. Check that the power supply is plugged into an electrical outlet.

2. Press the Power button on the rear panel. The Power LED should turn blue. The unit will start.

 Activating Your Device

For the first-time access, you need to activate the device by setting an admin password. No operation is

allowed before activation. You can also activate the device via a Web browser, SADP, or client software.

1. Enter the same password in the text

fields of Create New Password and

Confirm New Password.

2. In the IP Camera Activation text field,

enter the password to activate the IP

camera(s) connected to the device.

3. Click OK to save the password and

activate the device.

Click

Click again to hide password.

pluggable block

from the

to see password text.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

Figure 1-6 Controller Connection A (Typical)

Figure 1-7 Set Admin Password

Rev. 010918NA