Makita 4350FCT Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 4350FCT. Makita 4350FCT 13 halaman. Jig saw
Juga untuk Makita 4350FCT: Spesifikasi (2 halaman), Perincian Bagian (3 halaman), Buku Petunjuk (13 halaman), Informasi Teknis (14 halaman), Buku Petunjuk (13 halaman)

Halaman Cetak
Makita 4350FCT Buku Petunjuk
1
2
008008
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the
position shown in the figure. Pull the saw blade out
toward the base.
1
008009
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
1
008010
When not in use, the hex wrench can be conveniently
stored.

OPERATION

CAUTION:
Hold the tool firmly with one hand on the main
•
handle when performing the tool. If necessary, the
front part of the tool may be supported by the
other hand.
1. Blade clamp
3
2. Jig saw blade
3. Protrusions
1. Jig saw blade
1. Base
2. Hex wrench
2
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
1
008011
Turn the tool on and wait until the blade attains full
speed. Then rest the tool base flat on the workpiece and
gently move the tool forward along the previously
marked cutting line. When cutting curves, advance the
tool very slowly.

Bevel cutting

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
008012
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the bevel slot in the base.
1
2
008013
Tilt the base until the desired bevel angle is obtained.
The V-notch of the gear housing indicates the bevel
angle by graduations. Then tighten the bolt firmly to
secure the base.
7
1. Cutting line
2. Base
2
1. Base
3
2. Bolt
3. Hex wrench