CORNING PCH-02U Panduan Memulai Cepat - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kabel dan konektor CORNING PCH-02U. CORNING PCH-02U 10 halaman.
Halaman Cetak4.5.2 Installing Cable Using Buffer Tube Fanout (BTF) Kits
Step 1:
Terminate the fibers according to the
instruction provided with the bTF kit.
Step 2:
Install the fanout bracket using the
provided nuts.
Step 3:
Feed the fanout body and connectors
through the entry grommet.
Step 4:
Slide the drawer back completely and loop
the buffer tube under the fanout bracket
and around the radius control guides. Slide
the bTF truck body into the fanout bracket.
Install a cable tie to secure the fanout body
(Figure 10).
Step 5:
Route the connectorized fibers behind the
plastic tabs on the radius control guides.
Step 6:
Cut the provided hook-and-loop strap into
two pieces and feed the two straps into the
slots at the rear of the housing. Use the
straps to secure fibers as needed.
Step 7:
Remove blank panels by pinching the tabs together and pulling the panel away from
the opening. Install or remove connector panels by extending or depressing the
nylon fasteners on each end of the connector panel.
Step 8:
Remove dust caps from the connectors and adapters into which they will be mated.
Refer to Section 5 and clean the connector end-faces and the adapter per standard
company practices. Mate the connectors in the adapters.
4.5.3 Installing Cable Using Splice Trays
A splice tray bracket kit (p/n PC2-SPLC-6SR, purchased separately) is required to install splice
trays. Follow instructions provided with the splice tray bracket kit.
4.6
Documentation
Record fiber identification information appropriately on the provided identification label
(Figure 11). Accurate recordkeeping is imperative for an organized installation.
4.7
Closing the Housing
Step 1:
Lift up on stop latches and slide drawer toward the front of the housing to make sure
cable is not stressed. If necessary, readjust cable strain-relief to prevent stress on
fibers.
STANDARD RECOMMENDED PROCEDURE 003-722 | ISSUE 4 | OCTObER 2015 | PAGE 8 OF 10
Attach label here
KPA-0909
KPA-0155
Fanout body
Figure 10
Figure 11