Makita 4350T Informasi Teknis - Halaman 5

Jelajahi secara online atau unduh pdf Informasi Teknis untuk Alat Listrik Makita 4350T. Makita 4350T 14 halaman. Jig saw
Juga untuk Makita 4350T: Spesifikasi (2 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman)

Halaman Cetak

epair

[6] Assembling Gear housing cover section

1. Assemble Tool opener to Gear housing cover with referring to Figs. 1, 2 and 3 in page 3.

2. Put Leaf spring in Gear housing cover. Pay attention to its assembling direction. (Fig. 9)

Insert Rod into Gear housing cover. Pay attention to the direction of the hook of Blade holder as illustrated in Fig. 10.

Fig. 9

Tool opener

Rod

ass'y

Hook of Blade holder

3. After aligning the holes of Slider and Rod, insert Pin 4 into the aligned hole from left side as illustrated in Fig. 11.

4. Recline Slider fully and insert a pair of Linear guides as illustrated in Fig. 12.

Fig. 11

Hole of Rod

Holes of Slider

5. While lifting up the flat side of Leaf spring, lay a pair of Linear guides to put the flat side of Leaf spring on Linear

guides as illustrated in Fig. 13.

6. Move Slider to the center of Linear guides. Fasten Linear guides with four M4x10 Pan head screws as illustrated in Fig. 14.

Fig. 13

Lay Linear guides.

Lift up the flat side

of Leaf spring.

Fig. 14

Move Slider to the

center of Linear guides.

The two protrusions in

the Gear housing cover

Gear housing cover

Leaf spring

Face the roll portion

to the opposite side

of Gear housing cover

Face the hook of Blade

holder to the hook of

Tool opener when installing

Rod ass'y. Refer to Fig. 10.

Pin 4

(to the aligned hole)

Cross section of Gear housing cover

Linear guides

Gear housing cover

M4x10 Pan head screws

The ends of Linear guides

Fig. 10

Tool opener viewed from the bottom side

Hook of Blade holder

Gear housing cover

Fig. 12

Linear guides

Slider

Leaf spring

Note: Attach the ends of Linear guides to the two protrusions

in the Gear housing cover when fastening them.

P 5 / 14

Hook of Tool opener

Inside of Gear housing cover

Note: Linear guides have to be

put between Gear housing

cover and the flat side of

Leaf spring.