GARAN EWS-102 Pengaturan Sistem - Halaman 4

Jelajahi secara online atau unduh pdf Pengaturan Sistem untuk Unit Kontrol GARAN EWS-102. GARAN EWS-102 4 halaman.
Juga untuk GARAN EWS-102: Pengaturan Sistem (4 halaman), Pengaturan Sistem (4 halaman), Kalibrasi & Pengaturan (8 halaman), Informasi Tambahan (2 halaman)

Halaman Cetak

EWS-102 CONTROL UNIT

Analog output Selec�on (only available on Mul� Analog control unit)

OUT

There are seven selectable output ranges available. To view the current value press

scroll through output types. Select and save required option by pressing

4-20

Output type 4-20mA.

0-20

Output type 0-20mA.

0-24

Output type 0-24mA.

0-5

Output type 0-5V.

bi 5

Output type +/-5V

bi10

Output type +/-10V

CODE

ERR1

Sensor Signal Input - Negative

Err2

Insufficient Sensor Signal

Err3

Sensor Offset Too High - Positive

Err4

Sensor Offset Too High - Negative

Err5

Trying to calibrate without Control Signal link

Err6

Sensor not connected to EWS

Firmware 5.5 Rev 2 Booklet subject to alteration

4mA = no load, 20mA = full load

0mA = no load, 20mA = full load

0mA = no load, 24mA = full load

0V = no load, +5V = full load

-5V = no load, 0v + half load, +5V = full load

-10V = no load, 0v + half load, +10V = full load

ERROR

SYSTEM SETUP

ERROR CODES

CAUSE/SOLUTION

Reverse connection of sensor signal leads

Installation Error - Contact Garan

Fit link between control signal terminals

Connect sensor/check sensor wiring

www.garan.co.uk

then use

Page 4