Avantco Equipment MX30 Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengaduk Avantco Equipment MX30. Avantco Equipment MX30 15 halaman. Gear driven 30 qt. commercial mixer
Juga untuk Avantco Equipment MX30: Panduan Pengguna (15 halaman)

Halaman Cetak

User Manual

Cleaning

WARNING: DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE CLEANING

All new mixer bowls and accessories including whips, beaters, and dough hooks should be properly washed before use.

Wash with hot water and a mild soap solution and then rinse off with either a mild vinegar or soda solution and then rinse

again with clean water. It is highly recommended this cleaning procedure is followed for bowls and accessories prior to

whipping egg whites or whole eggs. The mixer should be cleaned daily with a clean damp cloth.

If the unit has not been used for some time, it is recommended that the procedure above is followed before mixer use.

It is important that the rear bowl lift guides are greased every three months to prevent corrosion.

Troubleshooting

Trouble

The axles can't work when

operating the machine

The mixing bowl is out of position

Leaks oil

Difficult to move the bowl up and down

The motor is overheated

and speed is down

Noise and overheating

Mixer touches bowl

Descviption

Sleeve

Gasket

Possible Causes

Poor contact of the electrical

equipment

Moving direction is not correct

Sealing washer is damaged

Slideway is rusted

The voltage is not enough, or

incorrect speed

Poor lubrication

The mixing device or bowl de-

formed

Qty

Solution

Check the Plug

Change

Clean the slideway and lubricate

Check the voltage or use

lower speed

Add or change lubrication

Repair or change the bowl

or mixing device