Makita 5091DWH Buku Petunjuk - Halaman 12

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 5091DWH. Makita 5091DWH 18 halaman. 85 mm (3-3/8")
Juga untuk Makita 5091DWH: Daftar Bagian (2 halaman)

Halaman Cetak
Makita 5091DWH Buku Petunjuk
Adjusting the depth of cut
Loosen the screw on the depth guide and move the base up or down. You can read the
depth of cut by aligning the top of the notch in the depth guide with the graduations on
i t s
right side. (Note
:
This can be done for 0" bevel cutting only.) At the desired depth of
cut, secure the base by tightening the screw.
guide
Base
1
Screw
I
Fig.
13
CAUTION
:
Depth guide
Fig. 1 4
0
Use
a
shallow depth of cut when cutting thin workpiece for cleaner, safer cuts.
0
After adjusting the depth of cut, always tighten the clamp screw securely.
Bevel cutting
Loosen the screw on the bevel
scale
plate
on the front of the base. Set for the desired
angle
(0"
-
45") by tilting accordingly,
then tighten the clamp screw securely.
Screw
Bevel scale plate
Fig.
l !
CAUTION :
After adjusting the depth of cut and bevel cutting angle, be sure to tighten the screw.
12