Makita 5091DWH Buku Petunjuk - Halaman 9
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 5091DWH. Makita 5091DWH 18 halaman. 85 mm (3-3/8")
Juga untuk Makita 5091DWH: Daftar Bagian (2 halaman)
Halaman Cetak
Installing or removing
the
battery cartridge
0
Always switch off the tool before insertion or removal of the battery cartridge.
0
To remove the battery cartridge, pull out
the set plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the tool.
To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
using the tool.
Battery cartridge
Fig.
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
Your new battery cartridge i s not charged.
You will need t o charge it before use. Use
the fast charger Model DC1201 t o charge
the battery cartridge.
*Plug the fast charger into the proper A/C
voltage source. The charging light will
flash in green color.
Insert the battery cartridge so that the
plus and minus terminals on the battery
cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port so that it rests on the charger port floor.
When the battery cartridge is inserted, the charging light color will change from green t o
red and charging will begin. The charging light will remain lit steadily during charging.
*When charging i s completed, the charging light color will change from red to green and
a tone will sound steadily for about 5 seconds.
After charging, unplug the charger from the power source. Refer t o the table below for
the charging time.
Fig.
Fast charger
DC1201
I
1200
I
Approx.
45
min
I
1201 / 1201A
I
ADDrOX. 60 min
9