Makita 5143R Buku Petunjuk - Halaman 8
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 5143R. Makita 5143R 12 halaman. Circular saw
Juga untuk Makita 5143R: Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (16 halaman), Buku Petunjuk (13 halaman)
Halaman Cetak
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting depth of cut
005392
CAUTION:
After adjusting the depth of cut, always tighten the
•
lever securely.
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Bevel cutting
1
005393
For model 5603R, 5703R,5705R, 5903R, 5103R
Loosen the clamping screws in front and back, and tilt the
tool to the desired angle for bevel cuts (0° - 45°). Secure
the clamping screws tightly in front and back after making
the adjustment.
For model 5143R
Loosen the clamping screw in front and tilt the tool to the
desired angle for bevel cuts (0 - 60°). Secure the
clamping screw tightly in front after making the
adjustment.
1. Lever
1
1. Clamping screw
1
Sighting
For 5603R, 5703R,5705R, 5903R, 5103R
5603R,5703R,5705R
B
1
005394
5903R/5103R
B
1
005449
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the B
position with it.
For 5143R
1
7
6
005396
Align your sight line with either the 0° notch for straight
cutting or the 30° notch for 30° angle cuts or the 45° notch
for 45° angle cuts or the 60° notch for 60° angle cuts.
Riving knife adjustment
1
2
3
4
1- 5mm
1- 5mm
005397
Use the hex wrench to loosen the hex socket head bolt
for the riving knife adjustment, then raise the lower blade
guard. Move the riving knife up or down over the two
protuberances for settings indicated in the figure, so as to
obtain the proper clearance between the riving knife and
8
1. Base plate
A
1. Top guide
2. Base
A
2
1. 60 ﾟ angle cuts
2. 45 ﾟ angle cuts
2
3
3. 30 ﾟ angle cuts
4
4. Straight cuts
5. Blade
6. Base
7. Top guide
5
1. Setting
protuberances
2. Hex socket head
bolt (For
adjusting riving
knife)
3. Setting
protuberances
4. Cutting depth