ALIBI ALI-DVR1004E Series Panduan Pengaturan Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk DVR ALIBI ALI-DVR1004E Series. ALIBI ALI-DVR1004E Series 6 halaman. 960h digital video recorder
Halaman Cetak
Generally, it is preferable to setup the DVR with a fixed network settings, if possible, to assure the DVR has an unchanging IP address
for remote logins. To enable fixed network settings, uncheck the Enable DHCP box, then edit the appropriate fields to change the
settings. Consult with your network administrator to determine the best network settings for your DVR. When finished, click Next.
7.
Click Next after you configured the network parameters. The HDD management Wizard window will open. If a new DVR is shipped
with a pre-configured HDD, nothing needs to be done in this window. If you installed an HDD or replaced the HDD, select (check the
box for) the HDD, then click Init to setup the disk for the DVR. NOTE: Init will erase all data from the disk. When the initialization is
complete, click Next to continue.
4
www.Observint.com
8.
In the camera setup wizard, you can initially select the recording mode for each camera attached to the camera input BNC connectors.
To use this menu:
a.
In the menu shown above, open Camera line drop down list to select the camera to configure. "1" (Analog 1) identifies the
camera plugged into the camera input BNC connector 1, "2" (Analog 2) identifies the camera on BNC connector 2, etc.
b.
To configure the camera for recording, click the Start Recording box to check it, then click the bullet for either Normal
(continuous) mode recording or Motion Detection mode recording.
c.
Do one of the following:
To copy these recording settings to other cameras connected to the DVR, click Copy, select the other cameras to you want
*
to apply the settings to, then click OK to save your settings.
To configure another camera differently, open the Camera graphical menu and select the next camera to configure. Then
*
repeat the steps above to configure the recording mode for that camera. You can also Copy these settings to other cameras.
After configuring the recording mode for each camera, click OK to confirm your settings and close the Wizard.
d.
Click here to open
the camera
graphical menu
© 2014 Observint Technologies. All rights reserved.