ALIBI ALI-HVR3008H Panduan Pengaturan Cepat - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk DVR ALIBI ALI-HVR3008H. ALIBI ALI-HVR3008H 8 halaman. Ali-hvr3000h series 4/8/16-channel 960h hd-tvi hybrid+ dvr
Halaman Cetak
In the screen above, you can also enable UPnP™ (Universal Plug and Play) and DDNS, Dynamic DNS to easily access your DVR from
outside the local network (i.e., the Internet). If setting up DDNS, the parameters you must configure depend on the DDNS server you
use. Refer to the ALI-HVR3000H DVR User Manual for more information about these features. Click Next to continue.
9.
In the HDD Management wizard, if a new DVR is shipped with a pre-configured HDD, nothing needs to be done with it in this window.
If you installed an HDD or replaced the HDD, that HDD needs to be initialized by the DVR before it can be used. Select (check the box
for) that HDD, then click Init to initialize the disk for the DVR. NOTE: Init will erase all data from the disk and can take several minutes
to complete. When the initialization is complete, click Next to continue.
10.
In the next window, the DVR will display all Alibi IP cameras it can find on the LAN. You can add any of these cameras to your DVR
if the number of cameras plugged into the BNC connectors on the backpanel plus the number of IP cameras you add here does not
exceed the channel capacity of your DVR (ALI-DVR3004H supports 4 camera channels, ALI-DVR3008H supports 8 camera channels,
etc.).
To add the IP camera shown in the screen below, click the box for the camera in the list you want to add to check mark it, then click the
Add button. Click Next to continue.
11.
In the camera recording screen, you can initially select the recording mode for each camera attached to the camera input BNC
connectors on the back panel and the IP cameras you added. By default, the DVR is configured to record the video from all cameras
continuously.
6
www.Observint.com
To use this menu:
a.
Open the Camera options graphical menu and select the camera to configure. "1" (Analog 1) identifies the camera plugged into
the camera input BNC connector 1, "2" (Analog 2) identifies the camera on BNC connector 2, etc. In the screen below, camera
"5" is the IP camera added in the previous screen.
b.
Click the Start Recording box to check it if not checked, then click the bullet for either Continuous mode recording or
Motion Detection mode recording.
c.
Do one of the following:
To copy these recording settings to other cameras connected to the DVR, click Copy, then select the other cameras to you
*
want to apply the settings to.
Click here to open
the camera
graphical menu
© 2014 Observint Technologies. All rights reserved.