KitchenAid Superbra KUDA220T Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring KitchenAid Superbra KUDA220T. KitchenAid Superbra KUDA220T 8 halaman. Undercounter dishwasher

Halaman Cetak

Now start...

with dishwasher

in kitchen.

Disconnect electric supply before

installing dishwasher.

Cut 1" holes

or water,

rain

and electrical lines within

shaded area.

The unshaded

area must

be free of pipes,

2..,.

drain hose or wires.

Rough in water

drain

and

lines to the dishwasher

cabinet opening using one of the

routing methods shown.

Cut 1" hole

in cabinet, rear wall or floor for water

and drain lines.

nstall a shutoff valve in the

water line where it can be

easily used.

lush water line to get rid of

any particles that may clog

inlet valve. Turn shutoff valve to the

"OFF" position.

heck that there are no

sharp bends or kinks in

water line that might restrict

water flow.

Install air gap.

Attach drain

hose to air gap or waste

tee. See "Drain requirements",

Numbers

correspond

to steps.

Electrical Shock Hazard

• Disconnect electrical power

at the service panel (fuse box

or circuit box).

• Make sure that the water

supply line, drain line and

wiring do not touch any

exposed terminals of the

dishwasher wiring.

Failure to do so could result in

serious injury or death.

Cut a 1 inch hole in the

cabinet for the electrical

wiring to pass through.

If this hole is

cut in a wood cabinet, the hole

should be sanded until smooth.

the hole is cut in a metal cabinet, the

hole must be covered by a grommet

(Part No. 302797).

Run flexible

cable from fused disconnect, circuit

breaker or junction box through hole

in cabinet. Cable should extend 24"

from back wall.

tabs

toe par

access

2 screws

Remove the 2 screws

below the access panel.

Press up on tabs and pull out bottom

of access panel to unhook tabs from

frame. Then pull the access panel

downward to slide the panel flanges

out from behind the support channel.

Set the access panel aside on a

protective covering.

Remove the 2

toe-panel screws.

Remove the toe

panel.

The dishwasher is shipped

to be installed in 34"

cabinet opening.

Measure height of

cabinet opening from underside of

countertop to floor. Adjust leveling

legs to required opening height.

Page 5