Makita 903DW Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 903DW. Makita 903DW 17 halaman. Cordless blade sharpener

Halaman Cetak
Makita 903DW Buku Petunjuk
ADDITIONAL SAFETY RULES
FOR CHARGER & BATTERY CARTRIDGE
1.
Do not charge Battery Cartridge when temperature is BELOW 10°C (SOOF)
or ABOVE 4OoC (104OF).
2.
Do not attempt t o use a step-up transformer, an engine generator or DC power
3.
Do not allow anything t o cover or clog the charger vents.
4.
Do not short the battery cartridge:
receptacle.
(1) Do
n o t touch the terminals
with
any conductive material.
(2)
Avoid storing battery cartridge in a container with other metal objects such
(3)
Do not expose battery cartridge t o water or rain.
A battery short can cause a large current flow, overheating, possible burns
and even a breakdown.
5.
Do not store the tool and Battery Cartridge in locations where the tempera-
ture may reach or exceed 5OoC (122OF).
6.
Do not incinerate the Battery Cartridge even if
it
is severely damaged or is
completely worn out. The battery cartridge can explode
in
a fire.
as nails, coins, etc.
ADDITIONAL SAFETY RULES
1. Be aware that this tool is always in an operating condition, because
it does
2.
Use only wheel points having a maximum operating speed at least as high
3.
Check the wheel point carefully for cracks or damage before operation.
4.
Hold the tool firmly.
5. Keep hands away from rotating parts.
6.
Before using the tool on an actual workpiece, let
it
run for more than one
minute. (When mounting a new wheel point, let
it
run for more than three
minutes.) Watch for vibration or wobbling that could indicate poor installa-
tion or a poorly balanced wheel point.
7. Watch out for flying sparks. Hold the tool so that sparks fly away from you
and other persons or flammable materials.
8.
Do not leave the tool running. Operate the tool only when hand-held.
9.
Always be sure you have a firm footing. Be sure no one is below when using
not have t o be plugged into an electrical outlet.
as
"No
Load
RPM"
marked o n the tool's nameplate.
Replace cracked or damaged wheel point immediately.
the tool in high locations.
IO.
Do not use water or grinding lubricant.
11. Do not use this tool as cutter.
12.
Do not touch the workpiece immediately after operation;
it
may be extremely
hot and could burn your skin.
5
SAVE THESE INSTRUCTIONS.