Makita AN942 Informasi Teknis - Halaman 2

Jelajahi secara online atau unduh pdf Informasi Teknis untuk Alat Listrik Makita AN942. Makita AN942 7 halaman. Pneumatic construction nailer
Juga untuk Makita AN942: Buku Petunjuk (20 halaman), Perincian Bagian (3 halaman), Buku Petunjuk (17 halaman)

Halaman Cetak

epair

Please refer to the following matters on the repair.

< 1 > General instruction.

< 2 > Disassembling head bulb section.

< 3> Assembling the head bulb section.

< 4 > Disassembling trigger section.

< 5 > Assembling magazine section.

< 6 > Attaching of driver complete.

< 7 > Repair to stop the leaking air.

< 1> General instruction

I. O rings and O ring part which contacts the sliding parts, have to be coated

with turbine oil (standard equipment), or grease (Isolex NB52), when the machine is

mounted.

II. Please refer to the following parts name.

III. The bolts have to be fastened as follows.

Bolt and Bolt size

Hex socket head bolt M6 x 25

Hex socket head bolt M5 x 30

Hex socket head bolt M8 x 25

IV. Confirm the following matters after mounting of the parts.

* Pusher can slide smoothly.

* Contact arm and trigger can move smoothly.

* Singly by pressing the trigger or contact arm, the machine does not start.

Exhaust cover

Top cap

Housing

Driver guide

Contact arm

Fastening section

Housing - Top cap

Housing - Inlet cap

Housing - Driver guide

Inlet cap

Trigger

Pusher lever

Fastening torque

9 - 13 Nm

(90 - 130 Kgf.cm)

5 - 7 Nm

(50 - 75 Kgf.cm)

20 - 30 Nm

(200 - 300 Kgf.cm)

P 2

Joint

Magazine