Makita AT638A Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita AT638A. Makita AT638A 13 halaman. Narrow crown stapler
Juga untuk Makita AT638A: Buku Petunjuk dan Panduan Pengguna (13 halaman)

Halaman Cetak

Use an air hose as large and as short as possible to

assure continuous, efficient stapling operation.

With an air pressure of 0.49 MPa (4.9 bar), an air hose

with an internal diameter of over 6.5 mm and a length

of less than 20 m is recommended when the interval

between each stapling is 0.5 seconds.

Air supply hoses shall have a minimum working pres-

sure rating of 1.03 MPa (10.3 bar) or 150 percent of the

maximum pressure produced in the system whichever

is higher.

Lubrication

To insure maximum performance, install an air set (oiler,

regulator, air filter) as close as possible to the tool.

Adjust the oiler so that one drop of oil will be provided

for every 50 staples.

When an air set is not used, oil the tool with pneumatic

tool oil by placing 2 (two) or 3 (three) drops into the air

fitting. This should be done before and after use.

For proper lubrication, the tool must be fired a couple of

times after pneumatic tool oil is introduced.

► 1 . Pneumatic tool oil

FUNCTIONAL

DESCRIPTION

CAUTION:

function on the tool, always return the trigger and

disconnect the air hose from the tool.

Adjusting depth of stapling

► 1 . Adjuster

To adjust the depth of stapling, turn the adjuster.

The depth of stapling is the deepest when the adjuster

is turned fully in the A direction shown in the figure. It will

become shallower as the adjuster is turned in the B direction.

If staples cannot be driven deep enough even when the

adjuster is turned fully in the A direction, increase the

air pressure.

If staples are driven too deep even when the adjuster is

turned fully in the B direction, decrease the air pressure.

Generally speaking, the tool service life will be longer

when the tool is used with lower air pressure and the

adjuster set to deeper depth of staple driving.

Hook

CAUTION:

tion or on potentially unstable surface.

CAUTION:

waist belt. If the stapler accidentally drops, it may

result in misfiring and personal injuries.

► 1 . Hook

The hook is convenient for hanging the tool temporarily.

5 ENGLISH

Before adjusting or checking

Never hook the tool at high loca-

Do not hang the hook from the