Makita BFL202F Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita BFL202F. Makita BFL202F 16 halaman. Cordless angle screwdriver
Juga untuk Makita BFL202F: Buku Petunjuk (12 halaman)

Halaman Cetak

LED indicator / Beeper

LED indicator / Beeper on the tool shows the following functions.

Function

Auto-stop fastening

Delayed re-start

Warning against

insufficient fastening

Warning for battery

cartridge capacity

Checking the

remaining battery

capacity, Autostop

Check the LED indi-

cator, lamp and

beeper operation

Anti-reset of control-

ler

Overheat

Operation error of

the switch trigger

Warning for limit of

the fastening capac-

ity

013073

Status

This function works when the tool has

reached the preset fastening torque

and normal tightening has been com-

pleted. This helps overtightening to

be avoided.

For approximately one second after

auto-stop fastening, the tool does not

start even if the switch trigger is

pulled.

Insufficient fastening has been per-

formed when the switch trigger has

released before reaching the preset

fastening torque.

This indicates the appropriate time to

replace the battery cartridge when

the battery power becomes low.

This function works when the battery

power is almost used up. At this time,

tool stops immediately.

This function works to check the

proper operation of the LED indicator,

lamp and beeper when a battery car-

tridge has been inserted into the tool.

This function works when an abnor-

mal drop of the battery voltage occurs

for some reason, and the tool stops.

This function works when the temper-

ature of the controller goes up very

highly, and the tool stops.

This function works to avoid the tool's

immediate start upon insertion of bat-

tery cartridge into the tool with the

switch trigger being pulled.

The tool automatically stops without

the clutch working when exceeding

the fastening capacity limit.

Status of the LED indicator/beeper

LED indicator

Beeper

Lights up in

green for

approximately

one second.

Lights up in red. A long beep

Flickers in red

A series of long

slowly.

beeps

Lights up in red. A long beep

Lights up first in

green, next red.

A series of very

(And then the

short beeps

lamp comes

on.)

Flickers in red

A series of short

and green alter-

beeps

natively.

Flickers in red

A series of short

quickly.

beeps

Flickers in red

A series of short

and green alter-

beeps

natively.

Flickers in red

A series of short

and green alter-

beeps

natively.

Action to be

taken

—

Retighten the

screw.

Replace the

battery with fully

charged one.

Replace the

battery with fully

charged one.

—

Replace the

battery with fully

charged one.

Remove the

battery car-

tridge immedi-

ately and cool

the tool down.

Release the

switch trigger.

Remove the

battery car-

tridge and then

install it again.

Be sure to use

the tool under

load within its

capacity.