GARCARE GPHT07 Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Pemangkas GARCARE GPHT07. GARCARE GPHT07 14 halaman. Corded pole hedge trimmer

Do not connect to power supply until assembly is complete, Failure to

comply could result in accidental starting and possible serious personal

injury.

Cutting Tips

Assume a secure position, using two hands to hold the hedge trimmer and switch on.

Trim both sides of the hedge, starting at the bottom. This prevents cuttings falling into the

area yet to be cut.

Pass the blade lightly through the surface of the hedge trimmer. Do not attempt to cut too

deep.

Trim the top of the hedge.

For older hedges that require cutting back substantially, use pruning shears to cut the

thicker branches and then finish the job with the hedge trimmer.

Never use the hedge trimmer without check the tightness of the bracket.

Warning! Before performing any work on the equipment, pull out the power

plug.

Check your machine regularly before starting the work.

Damaged cutting blades have to be repaired or exchanged by a qualified technician

before working with the machine.

After each cutting operation, clean the cutting blade with a soft brush and cloth with

lubricating fluid oil and spray a thin layer of fluid protective oil over the blades. Silicone

spray is recommended.

Always keep the ventilation slots in motor housing clean.

Never clean or spray a machine with water.Clean the motor housing only with a moist

cloth and never apply detergents or solvents! These could ruin the plastic parts of the

machine, finally dry the motor housing carefully.

Store the machine with the supplied safety blade cover (8).

Only use original accessories and spare parts.