James products SONIC 3D Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembersih Perhiasan Ultrasonik James products SONIC 3D. James products SONIC 3D 16 halaman.

Halaman Cetak

OPERATION INSTRUCTIONS

1)
Check the specification table for the correct operating requirements
(located on the rear of the unit).
2)
Before connecting power, put the unit on a stable and flat working surface.
Add water to tank, sufficient to completely immerse the items being cleaned.
Using the stainless steel basket is highly recommended. Never operate the unit without
water in the cleaning tank. Always fill the unit above 2/3 marker line indicated on the inside
of the tank. Failing to do so, may cause damage to the unit.
3)
Connect the power cable to the rear of the unit and ensure the wall supply is switched
ON. All the buttons are touch-sensitive, just lightly touch with your finger. Touch the
button on the front panel to turn on the machine. You are now ready to set the timer and
temperature.
4)
Setting the Temperature- When the power is on, the LCD will display the actual
temperature of the solution within the tank. The temperature setting figure will flash once
the
option is pressed to set temperature. It indicates that the temperature setting
function has been started. Then, press
When the set temperature is higher than the actual temperature, the built-in heater will
initiate the heating function. The working status (OFF and ON) is visible through the LCD
display window. When the heater has reached the necessary temperature, the heating
function will stop automatically. When the set temperature is lower than the actual one,
heating will not start automatically. In this case, the fluid will enter into the constant
temperature state. The heating function is not restricted by the ultrasonic cleaning timing
but can work for a long time (however, it is necessary to make sure there is enough
water inside the tank). To deactivate the heating function, input "00" in preset
temperature, then the Heater will be turned off.
button to set the required temperature.
7