Makita BJS161 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita BJS161. Makita BJS161 12 halaman. Cordless straight shears 1.6mm (16ga)
Juga untuk Makita BJS161: Buku Petunjuk (8 halaman), Informasi Teknis (9 halaman)

Makita BJS161 Buku Petunjuk
overloaded. Then turn the tool on to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before turning the tool on again.
Low battery voltage:
The remaining battery capacity is too low and
the tool will not operate. In this situation,
remove and recharge the battery.
NOTE:
The overheat protection works only with a battery
cartridge with a star mark.
1
012128
Switch action
1
010088
CAUTION:
Before inserting the battery cartridge into the tool,
always check to see that the switch lever actuates
properly and returns to the "OFF" position when the
rear of the switch lever is depressed.
Switch can be locked in "ON" position for ease of
operator comfort during extend use. Apply caution
when locking tool in "OFF" position and maintain
firm grasp on tool.
To start the tool, slide the switch lever toward the "I (ON)"
position. For continuous operation, press the front of the
switch lever to lock it.
To stop the tool, press the rear of the switch lever, then
slide it toward the "O (OFF)" position.
1. Star marking
1. Switch lever
6
Indication lamp with multi function
010089
Indication lamps are located in two positions.
Battery cartridge replacing signal
When the battery power is almost used up
during operation, the red lamp lights up and
the tool stops immediately. Replace the
battery with fully charged one when the red
lamp lights up.
Accidental re-start preventive function
Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)"
position, the tool does not start. At this time,
the lamp flickers slowly and this shows that
the accidental re-start preventive function is at
work.
To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide it
toward the "I (ON)" position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Adjusting the blade clearance
For BJS160 and BJS161 only
Adjust the clearance between the side blade and the
center blade according to the thickness of the workpiece.
1
010085
First use a hex wrench to loosen the screw.
1. Indicating lamp
1
1. Hex wrench
2. Screw
2