AIRFRAMES ALASKA ARCTIC OVEN GREAT NUNATAK Manual

Jelajahi secara online atau unduh pdf Manual untuk Tenda AIRFRAMES ALASKA ARCTIC OVEN GREAT NUNATAK. AIRFRAMES ALASKA ARCTIC OVEN GREAT NUNATAK 3 halaman.

Halaman Cetak
ARCTIC OVEN GREAT NUNATAK
The Great Nunatak is the perfect base camp tent when traveling deep into the
backcountry. Boasting huge space for gear and sleeping capacity, the Nunatak
allows for big adventures in those hard-to-reach places. With the implementation
of aviation engineering and learnings from advanced field testing, we've created
the most versatile hot tent line on the market.
TENT BODY AND POLE SET UP
- Open the tent pole bag and put together the 2 center poles (each pole has 4 sections). All
sections are designed the same, with the exception of the bottom section. The bottom section of
the poles will come preassembled with an adjustable pole and rubber stabilizer foot. Once you
have the center poles assembled, slip rubber gaskets onto the top of the poles and set aside.
- Use the remaining pole pieces to assemble the ridge pole, and set aside.
- Unfold the tent body and lay it out flat on top of footprint accessory. (Footprint sold separately.)
- Stake down the four corners of the body and each side firmly. Stretch the corners as tight and as
square as possible. Properly staking out your tent is very important with tension tents, make sure
you have the correct stakes for the terrain and season you are camping in. We supply Heavy Duty
Tent Stakes, but ice screws or snow stakes may be used during frozen winter months.
- Put the two halo's together. They will make two square pole configurations.
- Unzip the front door of the tent body to stand on the nylon floor.
- Attach each spider's four straps to the corners of the square halos. Wrap each strap around the
halo ring, connect Velcro and snap into corners of halo.
- Attach the square halo poles to the clips on top of the tent body.
- Install the ridge pole in between the two spiders as seen in the picture.
- Pull the tent fly over the tent body, straightening as needed. Make sure you
position the fly so the stove jack is over the stove opening on the tent body.
- Clip the fly into the Vapex body with provided buckles around the tent.
- Slide the main poles through the door openings and slip the orange spider tubing
into the center poles through the openings in the tent.
- Continue to lift up the tent until you can land the poles in the center of
reinforcements sewn into the floor and adjust the tension of the tent by
adjusting the leg in the bottom pole.
G R E AT N U N ATA K
Tent Parts Included
1
Tent Fly
1
Vapex Body
2
Center Poles
1
Ridge Pole
2
Rubber Gaskets, Lift Kit
1
Tent Pole Bag
2
Spiders With Straps
2
Square Halo Frames
1
Large Stuff Sack
28
HD Tent Stakes
Center Poles
Halo, spider, and
ridge pole setup.
Visual of tent after tent body and pole set up.
Ridge Pole