Makita BJV180 Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita BJV180. Makita BJV180 13 halaman. Cordless jig saw
Juga untuk Makita BJV180: Perincian Bagian (3 halaman), Lembar Spesifikasi (2 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman), Informasi Teknis (13 halaman), Buku Petunjuk (18 halaman)

Halaman Cetak
Makita BJV180 Buku Petunjuk
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole:
007492
For internal cutouts without a lead-in cut from an
•
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start your
cut.
B) Plunge cutting:
007493
You need not bore a starting hole or make a lead-in
•
cut if you carefully do as follows.
1.
Tilt the tool up on the front edge of the base with
the blade point positioned just above the
workpiece surface.
2.
Apply pressure to the tool so that the front edge of
the base will not move when you switch on the
tool and gently lower the back end of the tool
slowly.
3.
As the blade pierces the workpiece, slowly lower
the base of the tool down onto the workpiece
surface.
4.
Complete the cut in the normal manner.
Finishing edges
007494
1. Starting hole
1
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.
Rip fence set (optional accessory)
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing accessories.
1.
Straight cuts
007496
1
2
3
007497
When repeatedly cutting widths of 160 mm or less, use
of the rip fence will assure fast, clean, straight cuts. To
install, insert the rip fence into the rectangular hole on
the side of the tool base with the fence guide facing
down. Slide the rip fence to the desired cutting width
position, then tighten the bolt to secure it.
2.
Circular cuts
007498
9
1. Rip fence
1
1. Hex wrench
2. Bolt
3. Fence guide