Makita BJV180 Informasi Teknis - Halaman 2
Jelajahi secara online atau unduh pdf Informasi Teknis untuk Alat Listrik Makita BJV180. Makita BJV180 13 halaman. Cordless jig saw
Juga untuk Makita BJV180: Perincian Bagian (3 halaman), Lembar Spesifikasi (2 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman), Buku Petunjuk (18 halaman)
Halaman Cetak
R
epair
CAUTION: Remove the jig saw blade from the machine for safety before repair/ maintenance,
in accordance with the instruction manual!
[1] NECESSARY REPAIRING TOOLS
Code No.
Description
1R235
Round bar for arbor 6-100
1R291
Retaining ring S and R pliers
1R311
Retaining ring pliers
1R254
Torque wrench shaft 2-6N.m
A-33750
Bit adaptor assembly
1R222
Socket adaptor
1R220
Ratchet head 9.5
1R228* 1/4 Hex shank bit M4
*1R014 (1/4 Hex shank bit M4) can also be used.
[2] LUBRICATION and ADHESIVE APPLICATION
LUBRICATION
Apply Makita grease FA. No.2 to the following portions designated with the black triangle
to protect parts and product from unusual abrasion.
Item No.
Description
Linear guide
Slider
Push pin
Rod
Balance plate
Push plate
Gear housing complete
Fig. 1
Blade holder
ADHESIVE APPLICATION
If you remove M4x12 Hex socket head bolt from Crank complete,
be sure to apply Loctite 241/242 or Threebond 1321/1342 to the bolt
when reinstalling. (Fig. 2)
Locking Crank complete when removing/fastening
M4x12 Hex socket head bolt
Removing/installing Retaining ring S-8 from/on the shaft portion
of Gear housing Complete
Removing/installing Retaining ring R-18 from/on Blade holder
Removing/fastening M4x12 Hex socket head bolt from/to Crank complete
Groove portion where 28 Slider slides
Groove portion where Needle bearing 407 slides
Whole surface
Surface that contacts Gear housing cover complete
Inside surface of the large elliptic hole that contacts Gear complete
Each inside surface of the three small elliptic holes that contacts
corresponding pin on Gear housing complete
Surface that contacts Retainer
Surface that contacts Seal plate when Push plate moves downward
Upper, middle and lower portions of gear room
Gear housing cover complete
Seal plate
Apply machine oil #120 here
for smooth reciprocating of Rod.
Use for
Portion to lubricate
Needle bearing 407
Crank complete
Gear complete
Seal plate
Retainer
Fig. 2
Crank complete
Hex socket head
bolt M4x12
P 2 /13
Gear complete