GardaWorld 2GIG-CP21-345E2 Panduan Pengaturan Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Sistem Keamanan GardaWorld 2GIG-CP21-345E2. GardaWorld 2GIG-CP21-345E2 5 halaman. Diy alarm system

Halaman Cetak

Control panel

The control panel must be located near an AC outlet.

It can be placed at a different location within your

home depending on how you plan to arm and disarm

the system. The system can be remotely armed and

disarmed using a key fob (sold separately), or

through the SecureNet web application. If you prefer

to arm and disarm the system using a key fob or the

web application, we recommend placing the control

panel in a central area of the home, such as on the

kitchen counter. If you prefer to arm and disarm the

system using the control panel touchscreen, we

recommend placing the control panel near the front

door, so you have ample time to respect the arming

and disarming delay (approximately 30 seconds).

1. Detach the back plate from the panel by

removing the screw at the top rear of the

panel. Once the screw has been removed,

snap off the back plate by inserting the tip of

a flat-edge screwdriver into one of the two

slots located at the top rear.

2. Snap the plastic tip of the backup battery

wire into the connector slot.

Backup

battery

3. Reconnect the back plate and fasten it with

the screw.

4. Attach the desktop stand. The angled

deskmount stand snaps onto the rear of the

panel. It can be fitted as a high or low-

mounted stand and comes with 4 corner

grips to protect furniture and prevent sliding.

High-mounting option

Low-mounting option

5. Connect the power supply wires to the

transformer. Be careful to observe polarity.

6. Plug the transformer into a power outlet.