Alibi Security ALI-QVR5016H Panduan Pengaturan Jaringan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengaturan Jaringan untuk Kamera Keamanan Alibi Security ALI-QVR5016H. Alibi Security ALI-QVR5016H 4 halaman.

Halaman Cetak
Click the Activate button. In the Activate window, create a password for the admin (administrator) username:
2.
a.
In the Activate window, enter an a password for admin in the New Password field. Use a combination of uppercase, lowercase
alphabetic characters and numbers to create a "Strong" password. The rating is shown beneath the field. See above.
b.
Enter the admin password again in the Confirm field, and then click Activate. In the screen below, notice that the device
Security status shows "Active". Record your admin password for reference later.
If you lose your admin (administrator) password, you cannot configure the device or restore it to its factory settings. To reset your
password, call your support organization for specific instructions.
CAUTION
Notice that although the device is now activated, it retained the default IP address, 192.168.1.64.
2
www.AlibiSecurity.com
Activate
Step 3.
Modify Network Parameters
1.
In the list of devices discovered, click on the device you want to change the network settings for, click the select box to check it, and
then click the Modify Network Parameters button. See below.
2.
In the popup window, edit the current network parameters, and then enter the admin user password in the field at the bottom.
a.
Enable DHCP: You can select Enable DHCP to acquire compatible network settings from a DHCP server installed on the LAN.
However, these settings can be changed by the DHCP server. Since it is recommended to use an unchanging IP address, you can
use DHCP to acquire compatible network settings, and then uncheck Enable DHCP and save that configuration to retain the
new network parameters.
b.
In the example below, the IPv4 address was changed to 192.168.3.100, and the IPv4 Gateway was changed to 192.168.3.1. These
settings were determined to be compatible with the network router and other devices that share the same router.
3.
Click OK to save your settings. The parameter change(s) will be shown device's network parameters (see below).
Modify Network Parameters
© 2018 Observint Technologies. All rights reserved.