Corsa 14164 Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Kap Ventilasi Corsa 14164. Corsa 14164 5 halaman. Cat-back exhaust system, 2006 chevrolet corvette z06 axle back system with single pro-series 4.0” tips, 2006 chevrolet corvette z06 axle back system with twin pro-series 4.0” tips, 2006 chevrolet corvette z06 xo-pipe

Halaman Cetak

7. Slide the now loose flanges on the H-pipe towards the rear of the car

until they clear the studs and pull the entire H-pipe assembly out of

the car. The driver side pipe, leading to the muffler, should slide from

the clamp that was loosened in step 4. (See Fig. G & H)

NOTE: Push H-pipe towards rear to avoid damaging donut gasket.

8. Locate the vacuum lines attached to the outlet side of each muffler, near

the tips. Detach line from each muffler. No tools are required. (See Fig. I)

9. Starting with the passenger side, remove the rear mufflers from the

two rubber grommets holding each muffler in place. Use soapy water

to facilitate removal. (See Fig. J)

10. The muffler is now free and should be removed from the car by pulling

the muffler down while the attached pipe goes over the axle. (See

Fig. K & L)

11. Repeat steps 9&10 for the driver side.

12. Remove the soft rubber end from vacuum line if it did not stay attached

to the muffler assembly. (See Fig. I)

FIG. I

CORSA Exhaust System Installation:

NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure

to follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize

lubricant, be sure to thoroughly clean hands as lubricant will tarnish stainless steel.

All clamps should be tightened using a properly calibrated Torque Wrench. Using an air impact gun will damage the

clamp and reduce its ability to effectively seal the joint. It may also cause the joint to separate thereby causing

damage to your exhaust system and your vehicle.

INSTALLATION INSTRUCTIONS / CAT-BACK EXHAUST SYSTEM

2006 Chevrolet Corvette Z06 Axle Back System

With Single Pro-Series 4.0" Tips

2006 Chevrolet Corvette Z06 Axle Back System

With Twin Pro-Series 4.0" Tips

2006 Chevrolet Corvette Z06 XO-Pipe

FIG. J

FIG. K

PART NUMBER 14172

PART NUMBER 14164

PART NUMBER 14173

FIG. G

FIG. H

FIG. L