AVANTO 177IC1800P Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Rentang AVANTO 177IC1800P. AVANTO 177IC1800P 11 halaman. 1800 watt countertop induction range with probe cooking

Halaman Cetak

User Manual

Error codes

Error

Scenario

No cookware or

non-usable cookware

Low-voltage

High-voltage

Top plate sensor overheat or

short circuit

Top plate sensor open circuit or

without connection

1) The sensor has been damaged.

Could be damaged during

the shipping

2) The connection of sensor and

PCB is bad because the fasteners

are loose

IGBT sensor overheat or short circuit

or fan without connection

Check Point

Remedy

Please make sure you are using the correct and

high-quality, induction-ready cookware. Steel, cast

iron, enameled iron, or stainless steel with flat-bottom

pans / pots with diameter from 5" to 10". Unit will not

switch ON to heat. Unit will switch to Standby mode

after 1 minute.

Error code E1 occurs when the voltage is lower than

100V. Please ensure voltage is higher than 100V.

Error code E2 occurs when the voltage is higher than

280V. Please ensure Voltage is lower than 280V.

1) Error code E3 occurs when the temperature of

sensor overheats and boil dry protection is activated

(which can be caused when the temperature of

cookware is over 450F) during cooking. The

induction cooker needs to be turned off, unplugged,

and allowed to cool. Then you can turn it back on.

2) If E3 occurs after following step above, then

sensor has failed. Please contact customer service.

If you can see loose wires, then contact

customer service.

1) If error code E5 occurs and the cooling fan is

still functioning, please contact customer service.

2) If error code E5 occurs and the cooling fan has

stopped functioning or is not running well, check

to see if anything is lodged in or jamming the

cooling fan.