GARDEN MASTER GM1818 Manual Petunjuk Perakitan - Halaman 3
Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Penyimpanan Luar Ruangan GARDEN MASTER GM1818. GARDEN MASTER GM1818 8 halaman. Sloping roof shed
Juga untuk GARDEN MASTER GM1818: Petunjuk Perakitan (2 halaman), Manual Petunjuk Perakitan (8 halaman)
Halaman Cetak
STEP 1:
BACK WALL
/
1.
Join 2
sheets together with 2 rivets through the overlapping
1
A
2
ribs making sure the ends of the sheets are flush.
2.
Cap sheeting with
G
and bottom. This will finish 10-15mm shorter than the sheet.
3.
Rivet the channels through the end ribs and every 2nd rib between.
4.
Make sure you put at least 1 rivet per sheet up through the underside
of the channel into the pan of the sheet.
CHANNELS WITH CUTOUTS
The cutouts go to the inside of the panel to
allow easy fitment of the end walls
on assembly. Note top and bottom
channels have different cutouts!
TOP
CHANNEL
STEP 2:
ROOF
/
1.
Join 2
1980mm sheets together, same as the back.
1
C
2
2.
Cap sheeting with
F
3.
Rivet the channels at every second rib but
not the corners at this stage.
4.
Place the short flange of the 'L' on top of the rib at one end. Make
sure ends are flush with sheeting (diagram 1) and put one rivet in
the centre to hold the 'L'. Rivet the corners through the channels
and one more between the corner and the centre rivet. Perform
the same at the other end. 5 rivets for each 'L'.
WATCH OUR
SHED ASSEMBLY
VIDEO GUIDE
HERE
channels putting the cutouts top
BOTTOM
CHANNEL
1815mm channels.
If you need advice, call us
G
H
F
FREE
on
0800 807 433
or email us at [email protected]
If you choose to vary from these instructions your warranty will be impaired.
YOU WILL NEED:
2
A
x 1830mm sheets for the back
1 / 2
1 x 1815mm top channel
G
1 x 1815mm bottom channel
GARDEN MASTER TIP
Put extra rivets in for high wind areas,
particularly on the underside.
G
A
YOU WILL NEED:
C
2
x 1980mm sheets
1 / 2
F
2 x 1815mm channels
H
2 x 1980mm 'L's
F
C
H
WATCH OUR
SHED ASSEMBLY
VIDEO GUIDE
HERE
3