KitchenAid YKFEG500ESS Panduan Pemilik - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Rentang KitchenAid YKFEG500ESS. KitchenAid YKFEG500ESS 18 halaman. Freestanding
Juga untuk KitchenAid YKFEG500ESS: Panduan Petunjuk Instalasi (20 halaman), Panduan Memulai Cepat (2 halaman)

Halaman Cetak

1. Clean Cycle

Install Anti-Tip Bracket

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation

instructions.

Slide range back so rear range foot is engaged in the

slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed

and engaged.

Failure to follow these instructions can result in death or

serious burns to children and adults.

1. Remove the anti-tip bracket from where it is taped inside the

storage drawer or warming drawer.

2. Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor, you can use the wall

mounting method. If you are installing the range in a mobile

home, you must secure the range to the floor.

3. Determine and mark centerline of the cutout space. The

mounting can be installed on either the left-side or right-side of

the cutout. Position mounting bracket against the wall in the

cutout so that the V-notch of the bracket is 12

from centerline as shown.

A. 12

" (31.9 cm)

B. Bracket V-notch

4. Drill two 1/8" (3 mm) holes that correspond to the bracket

holes of the determined mounting method. See the following

illustrations.

Floor Mounting

Wall Mounting

5. Using the Phillips screwdriver, mount anti-tip bracket to the

wall or floor with the two #12 x 1

provided.

6. Move range close enough to opening to allow for final

electrical connections. Remove shipping base, cardboard or

hardboard from under range.

7. Move range into its final location, making sure rear leveling leg

slides into anti-tip bracket.

" (31.9 cm)

8. Move range forward onto shipping base, cardboard or

hardboard to continue installing the range using the following

installation instructions.

Level Range

Determine if you have AquaLift

referring to the "Range Maintenance and Care" section.

For Ranges with AquaLift

Clean:

1. Place level on the oven bottom as indicated in one of the two

figures below depending on the size of the level. Check with

the level: side to side and front to back.

2. If range is not level, pull range forward until rear leveling leg is

removed from the anti-tip bracket.

3. Follow the directions in Style 1 or Style 2, depending on the

style of drawer supplied with the range.

Rear Position

Front Position

Technology or Steam Clean by

® ®

Diagonal (2 options)

" (41.3 mm) screws

Technology or Steam