Jancy Engineering Slugger 2x2 17982 Panduan Operator - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Operator untuk Bor Jancy Engineering Slugger 2x2 17982. Jancy Engineering Slugger 2x2 17982 16 halaman. Slugger portable magnetic drilling machine

Halaman Cetak
Improperly connecting the grounding wire can result in electrical shock.
Check with a qualified electrician if you are in doubt as to whether the outlet is
properly grounded. Do not modify the plug provided with tool. Never remove the
grounding prong from the plug. If the cord or plug is damaged, have it repaired
before using. If the plug will not fit the outlet, have a proper outlet installed by a
qualified electrician. The 2x2 must be plugged into an appropriate outlet, properly
installed and grounded in accordance with all codes and ordinances. The plug
and outlet should look like those in Figure A.
do not use slugger drilling machines on surfaces or materials being
.
welded
doing so can result in personal injury and
.
slugger drilling machine
Use only 3-wire extension cords that have 3-prong grounding-type plugs and 3-pole receptacles that accept the tool's
plug. Replace or repair damaged cords. Make sure your extension cord is in good condition. When using an extension
cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and overheating. Jancy recommends using a minimum 12 gauge extension cord
not to exceed 100 feet. The table below is supplied only as a guide to minimum gauge for extension cords, where the
smaller the gauge number, the heavier the cord.
minimum gauge for extension cords
volts
total length of cord in feet
120V
0-25
26-50
240V
0-50
51-100
amperage
0-6
18
16
6-10
18
16
10-12
16
16
12-16
14
12
recommended
wire
gauge
*
jancy
recommends
using
a
minimum
100
.
cord
not
to
exceed
feet
6
grounding instructions
WARNING!
WARNING!
/
or damage to the
extension cords
12
gauge
extension
dRiP LOOP: To help prevent cutting fluids from traveling
along power cord and contacting power source, tie a drip
loop in power cord as shown in Figure B.
Fig. B