Jands Vista M1 Setup Manual - Halaman 2

Jelajahi secara online atau unduh pdf Setup Manual untuk Peralatan Pencahayaan Jands Vista M1. Jands Vista M1 8 halaman. Usb consoles
Juga untuk Jands Vista M1: Setup Manual (8 halaman)

Halaman Cetak

This product is approved for use in Europe and Australia/New Zealand and conforms to

EN55103-1, EN55103-2, and EN60950. Conformance has been achieved for intended usage in

environment E1: Residential.

To ensure continued compliance with EMC Directive 89/336 and the Australian

Radiocommunications Act 1992, use only high quality data cables with continuous shield, and

connectors with conductive back shells. Examples of such DMX cable is Belden 8102 (100%

Aluminium foil screen, 65% Copper braid)

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not properly installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•

reorient or relocate the receiving antenna;

•

increase the separation between the equipment and receiver;

•

connect the equipment into an outlet on a different circuit from that to which the receiver is

connected;

•

consult the dealer or an experienced radio/television technician for help.

Disclaimer

Information contained in this manual is subject to change without notice and does not represent

a commitment on the part of the vendor. Jands Pty Limited shall not be liable for any loss or

damage whatsoever arising from the use of information or any error contained in this manual.

It is recommended that all service and repairs on this product be carried out by Jands Pty

Limited or its authorised service agents. Jands Pty Limited cannot accept any liability

whatsoever for any loss or damage caused by service, maintenance or repair by unauthorised

personnel, or by use other than that intended by the manufacturer.

Jands lighting products must only be used for the purpose they were intended by the

manufacturer and in conjunction with the user manual. Disconnect mains power when not in

use.

JANDS Pty Limited

Locked Bag 15

MASCOT NSW 1460

Sydney AUSTRALIA

Phone: +61-2-9582-0909

Fax:

+61-2-9582-0999

Jands USB Console Setup Guide Version 1.0

ACN 001 187 837

40 Kent Rd

MASCOT NSW 2020

Sydney AUSTRALIA

http://www.jands.com.au

http://www.jandsvista.com