Jandy Jandy Pro Series Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Penyaringan Air Jandy Jandy Pro Series. Jandy Jandy Pro Series 20 halaman. Single element cartridge pool & spa cs filters
Juga untuk Jandy Jandy Pro Series: Panduan Pemilik (12 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi dan Pengoperasian (20 halaman), Manual (8 halaman), Panduan Memulai Cepat (2 halaman), Panduan Instalasi dan Pengoperasian (20 halaman), Petunjuk Instalasi (2 halaman), Panduan Instalasi dan Pengoperasian (16 halaman), Panduan Instalasi dan Pengoperasian (16 halaman), Panduan Instalasi dan Pengoperasian (16 halaman)

Halaman Cetak

1. Section 10. Troubleshooting

Nicheless Underwater LED Lights | Owner's Manual

Section 3.

Risk of Electrical Shock or Electrocution.

must be installed by a licensed or certified electrician or a qualified pool

serviceman in accordance with the National Electrical Code

Electrical Code, in Canada) and all applicable local codes and

ordinances. Improper installation will create an electrical hazard, which

could result in death or serious injury to pool or spa users, installers or

others due to electrical shock, and may also cause damage to property.

Always disconnect the power to the light at the circuit breaker before

installing or servicing the light. Failure to do so could result in death or

serious injury to serviceman, pool or spa users or others due to electrical

shock.

NOTE: Jandy Pro Series Nicheless Lights are Low Voltage and do not

have any exposed metal and as such do not require a separate ground or

bonding wire.

3.1

Preparing the Light Fixture for Installation

NOTE: The electrician must complete preparatory steps before light fixture

is installed. See Figure 1.

Verify that the pool meets the requirements of the current National Electri-

cal Code

(Canadian Electrical Code, in Canada)

ordinances. A licensed or certified electrician must install the electrical

system to meet or exceed those requirements before the underwater light is

installed. Some of the requirements of the National Electrical Code, which

the pool electrical systems must meet, are as follows:

The junction box or the low-voltage magnetic transformer must be

located at least eight (8) inches (measured from the inside of the

bottom of the junction box or transformer) above the MAXIMUM

water level, OR at least four (4) inches above the ground level or pool

deck, whichever is greater. The junction box or 12VAC magnetic

transformer must also be installed at least forty-eight (48) inches (4 ft.)

from the edge of the pool. See Figure 1.

1.5" pipe must be installed through the bond beam followed by 1"

conduit for the cord using sweep elbows only for turns. Do not use 90

degree elbows. It is highly recommended to use 1.5" pipe throughout

the entire width of the bond beam, however, the minimum length for

the particular light being installed is specified in Table 1.

Installing the Jandy Pro Series

Nicheless LED Light

WARNING

ENGLISH

This underwater light

and all local codes and

Page 5

(Canadian